ATON Triggers, From AH66T, #3-4, A275 #1, A275 #2, To A275’s, 4 Remote Trigger In

A T O N A275 INSTALLATION MANUAL

Triggers

A REMOTE TRIGGER IN port allows all channels to turn on or mute simultaneously. The REMOTE TRIGGER INPUT can receive 5-24 Volts AC or DC. The 12 Volt DC REMOTE TRIGGER OUT can be used to turn on other equipment, additional A275s or other amplifiers, or to perform automated functions desired by the user. Use 3.5mm mono interconnect cables to make Trigger connections.

SYSTEM TRIGGER IN

To mute/un-mute all channels simultaneously, connect a system-wide 5-24 Volt DC triggering source to the SYSTEM TRIGGER IN port using a 3.5mm mono interconnect cable. Examples of triggering sources include an ATON Multi-Zone Controller’s SYSTEM  TRIGGER OUT or REMOTE OUT, an A/V receiver’s switched outlet connected to a power supply, or a +12VDC TRIGGER OUT from another ATON amplifier.

3.5mm mono interconnect cable

AH66T A275

Figure 3-4: Remote Trigger In

SYSTEM TRIGGER OUT

Whenever the A275 is powered ON, the REMOTE TRIGGER OUT becomes active. This output sends a +12VDC 100mA signal to other devices with a Trigger Input.

From AH66T

	To A275’s
	#3-4
	3.5mm mono interconnect cable
A275 #1	A275 #2
	Figure 3-5: Remote Trigger Out
© ATON 2010 • All rights reserved.	Page 11