ATON A275 Connections, From Audio, RCA Patch Cable, Output Source, Line Level Audio Inputs

A275 INSTALLATION MANUAL A T O N

Chapter 3: Connections

The A275 has several rear panel connections so it is important to label all cables and wires correctly. Label all input/output cable and speaker wires with their destination or source. This will save time during installation and any future upgrades to the system.

Use high quality line level RCA connector type cables for source connections to ensure the lowest possible noise and best sound per- formance. For most applications use 16AWG 2 conductor speaker cable. For wiring runs longer than 80 ft. it is recommended to use 14AWG 2 conductor speaker cable. The A275's high quality, gold plated 5-way binding post will accommodate speaker cabling sizes up to 12AWG. Attaching banana plugs will enable the connection of larger cable sizes. A 3.5mm mono interconnect cable may be used for amplifier and systems triggering.

Line Level Audio Inputs

Connect the zones by inserting the RCA connectors into the dedicated direct input jack on each channel.

A275	From Audio
	Output Source

RCA Patch

Cable

Figure 3-1: Line Inputs

	© ATON 2010 • All rights reserved.
Page 8