ATON A275 installation manual Whitered, Greenblack, 3 Speaker Binding Post

A275 INSTALLATION MANUAL A T O N

Speaker Binding Post

The A275 is equipped with gold plated, 5-way speaker binding posts. This allows five methods of speaker wire termination: bare wire, spade lug, pin, single banana and dual banana plug. Label all speaker wires with their destination to ensure easy configuration. To attach speaker wires use the following method:

1.Carefully split the speaker wire insulation at least two inches.

2.Strip 1/2 inch of the insulation from the speaker wire conductor exposing the bare wire.

3.Twist the wire strands of each conductor, if using banana plugs, attach wire to banana plug observing polarity.

4.If using banana plug; insert plug ends into binding post observing correct polarity. If using the bare wire method; loosen the binding post caps and insert the bare wire through the hole in the post. Tighten the knob until the wire is securely clamped.

CAUTION! Speaker Wire connections must be made with the amplifier OFF!

Banana Plugs

1/2’

Speaker Wire Speaker Wire

WHITERED

A275 Amplifier

Binding Post

GREENBLACK

WARNING: Do not allow any strands of the bare speaker wire to touch the Amplifier Chassis or another Connector.

Figure 3-3: Speaker Binding Post

	© ATON 2010 • All rights reserved.
Page 10