HUAWEI VP9050 Executive Video Terminal |
|
User Guide | 6 Conference Initiation |
To set conference parameters, do the following:
Step 1 Select Settings > Conference, and then set the parameters listed in Table
Table
| Parameter |
| Description |
|
|
|
|
| |
| Audio protocol |
| This specifies the audio protocol used by the terminal to encode and | |
|
|
| decode the audio. |
|
|
|
|
| |
| Video protocol |
| This specifies the video protocol used by the terminal to encode and | |
|
|
| decode the video. In a |
|
|
|
| protocol is the video protocol used by the local terminal. |
|
|
|
|
| |
| Video resolution | You can select a proper format based on the video protocol that is |
| |
|
|
| already set. |
|
|
|
| When the video protocol is set to auto, the video format can be |
|
|
|
| Sharp or Smooth. |
|
|
|
| When Sharp is selected, the system prioritizes the frame rate. When | |
|
|
| Smooth is selected, the system prioritizes the video resolution. |
|
|
|
|
| |
| Video frame rate | This specifies the video frame rate, that is, the frequency at which |
| |
|
|
| the imaging device produces unique frames. The higher the frame |
|
|
|
| rate, the smoother and clearer the video. It is recommended that you | |
|
|
| select Auto. |
|
|
|
|
| |
| Enable H.239 |
| After this check box is selected, presentations can be shared during | |
|
|
|
| |
|
|
| ||
| Dynamic bandwidth | If this function is enabled, when the ratio of the packet loss caused | ||
|
|
| by insufficient bandwidth in the network increases, the terminal |
|
|
|
| decreases the conference bandwidth automatically until the packet |
|
|
|
| loss does not occur constantly in the network or the conference |
|
|
|
| bandwidth is decreased to 64 kbit/s. Using the policy of dynamically | |
|
|
| adjusting the bandwidth, the terminal can stabilize the bandwidth |
|
|
|
| within one minute after packet loss occurs in the network. |
|
|
|
| When the network condition is good, select Disable. |
|
|
|
| When the network condition is poor, select Enable. |
|
|
|
|
| |
| Conference line | This specifies the type of the line used during a multipoint |
| |
| type |
| conference. |
|
|
|
| If Auto is selected and the terminal is registered with a GK, an IP |
|
|
|
| line is preferentially used for the multipoint conference. |
|
|
|
|
|
|
| Conference |
| The default value is Normal. |
|
| bandwidth |
| When the terminal accesses network using an IP line, set the |
|
|
|
| conference bandwidth to Limited to enhance the quality of the |
|
|
|
| video conference. |
|
|
|
| ||
| Select conference | This specifies the conference control options to be displayed on the | ||
| control operation | Conference Control screen. |
| |
|
|
|
| |
Step 2 Save the settings. |
|
| ||
|
|
|
|
|
Issue 03 | Huawei Proprietary and Confidential | 43 | ||
Copyright © Huawei Technologies Co., Ltd
