Huawei VP9050 manual Setting QoS Parameters, Enable Snmp, Get community name, Set community name

HUAWEI VP9050 Executive Video Terminal
User Guide	3 Network Settings

To set the terminal's SNMP parameters, do the following:

Step 1 Choose Settings > Network > IP > SNMP, and then set the parameters listed in Table 3-6.

Table 3-6SNMP parameters

	Parameter	Description
	Enable SNMP	Enabling SNMP allows the administrator to manage the
		terminal remotely using the MediaManager.
	Get community name	This specifies the read-only SNMP community name. The
		character string can consist of any characters on the keyboard
		and its length ranges from 0 to 32 characters. The SNMP
		version and the corresponding protocol parameters on the
		network management side need to be consistent with those on
		the terminal side.
	Set community name	This specifies the read-write SNMP community name. The
		character string can consist of any characters on the keyboard
		and its length ranges from 0 to 32 characters. The SNMP
		version and the corresponding protocol parameters on the
		network management side need to be consistent with those on
		the terminal side.
	Trap server address 1	This specifies the IP address that receives trap packets and is
	Trap server address 2	the IP address of the computer where the service client of the
		videoconferencing network management system is installed.
	Trap server address 3
		A trap is a message sent from a device being managed (for
		example, a terminal) to the videoconferencing network
		management system. The message is used to report emergent
		and important events. Trap packets are sent to a preset target
		trap device.
		For details about the videoconferencing network management
		system, see the HUAWEI iManager V2000 User Manual.
Step 2 Save the settings.
----End

3.3.6 Setting QoS Parameters

You can configure quality of service (QoS) settings to set the mode of processing IP data packets in a conference call.

To set the terminal's QoS parameters, do the following:

Step 1 Choose Settings > Network > IP > QoS, and then set the parameters listed in Table 3-7.

Issue 03 (2011-12-10)	Huawei Proprietary and Confidential	19
	Copyright © Huawei Technologies Co., Ltd