Fujitsu ST4000 warranty Network Settings, Click OK, Close Network Connection

S t y l i s t i c S T 4 0 0 0 S e r i e s T a b l e t P C U s e r ’ s G u i d e – A p p e n d i x

	Item		Description
Key		Click the down arrow and select the input
Format		for the Network key.
		ASCII	Select this when using
		characters	ASCII characters for the
			Network Key. Characters
			that can be used follow:
			0-9, A-Z, a-z, and
			_ (underscore)
			Example: To set the key to
			“ABC12”, input “ABC12”.
		Hexa-	Select this when using
		decimal	hexadecimal characters for
		characters	the Network Key.
			Use this if there is a wireless
			LAN card in the network
			that has the Network Key
			set to a character code. In
			’Network Key’, input the
			same value as the other
			wireless LAN card.
		Table 8: Setting parameters

8.When you finish your entry, click [OK]. [Wireless Network Connection 2 Properties] appears again.

9.Make sure the network name you specified for the SSID in Step 7 is added under [Preferred networks].

Network Connection

The section describes how to set the network connection for a computer running Windows XP.

Network Settings

In this section, you set “TCP/IP Settings,” and complete “Checking Computer Name and Workgroup” required for the network connection.

TCP/IP Settings

1.On [Wireless Network Connection Properties], click [General].

P O I N T

If [Wireless Network Connection 2 Properties] is not displayed, click [Start] -> [Settings] -> [Control Panel], and double-click the [Network Connection] icon.

Right click the [Wireless Network Connection], and then click [Properties] from the menu that appears.

2.Perform the following steps.

■Click [Internet Protocol (TCP/IP)].

■Click [Properties]. [Internet Protocol (TCP/IP) Properties] appears.

3.Set an IP address. Ask your network administrator and check the setting.

Item	Description
AdHoc	Set the IP address and subnet mask.
Network	Click [Use the following IP address].
	Enter a value for [IP address] and
	[Subnet mask]. See “Setting IP
	Addresses” on page 58 to set IP
	address and subnet mask.
For	Select [Obtain an IP address
Infrastructure	automatically]. For the DNS server,
Network	select [Obtain DNS server address
	automatically]. For the IP address,
	DNS server, and default gateway,
	follow the network administrator's
	instructions, if any.

Table 9: Setting an IP address

5. Click [OK].

P O I N T

If you have changed the setting, [Close] is shown instead. Click [Close].

6. Close [Network Connection].

Checking the Full Computer Name and Workgroup

1.Click [Start] -> [Control Panel]. Make sure the Classic View is selected.

2.Double-click the [System] icon. [System Properties] appears.

3.Click the [Computer Name] tab.

4.Check [Full computer name] and [Workgroup]. Ask your network administrator and check the setting.

Item	Description
Computer	A name to identify the computer on
Name	the network. You can specify any
	name to each computer. Use up to 15
	single-byte characters. For easier
	identification, use the model name or
	user name.

52