2. Safety notes
•Place the TV set on a solid surface which is capable of bearing the weight!
•If you bring a cold TV set into a warm room, wait until any condensation has evaporated before switching it on.
•The TV set is intended for use in dry rooms. If, in exceptional cases, you want to use it outdoors, take care that it is not exposed to moisture (rain, splashwater, dew).
•TV sets need sufficient cooling to pre- vent them from overheating. Ensure that the slots in the rear cover are not blocked by curtains, doily, newspa- pers, etc. Also keep the slots on the bottom of the set free so that cool air can enter the set.
•If you install the TV set in a wall cabi- net, ensure that there is sufficient space around it to permit the circulation of cooling air.
•Do not position the TV set in the imme- diate vicinity of a radiator or other heater, since this could cause it to overheat.
•Do not place
-burning candles
-vases, etc. containing liquids
on or above the TV set. Hot wax or other liquids which enter the set will destroy its electronic components. In such cases, safe operation of the set is no longer guaranteed.
•Thunderstorms can damage electrical devices. Lightning hitting overhead power cables or the antenna can cau- se considerable damage to the set, even if it is switched off. If there is a risk of a thunderstorm, you should
remove the power cable from the wall outlet and disconnect the antenna cable from the outlet or from the TV set.
•Only suitably trained persons may open the set and/or carry out repairs.
CAUTION: RISK OF ELECTRIC SHOCKS!
If repairs should be necessary, please consult your local dealer.
•Always switch off the TV set with the mains switch before cleaning it!
•Do not point the remote control into your eyes and press any keys. The infrared radiation can damage your eyes!
•Do not use rechargeable batteries in the remote control. Use only two dry batteries of the type LR03/AM4/AAA 1.5V Micro.
•The TV set is intended only for the reception and display of picture and sound signals.
•The TV set may be operated only from
a mains voltage of 220 – 240VAC ˜, 50Hz.
•Lay the mains cable so that
•Repairs may be carried out only by suitably qualified persons.
5