3. The remote control
1.Programming the remote con- trol for the individual devices
In order to control your various devices with the remote control, you must first programme it with a
•TV (TV set)
The TV operating level is programmed in the factory for the Metz 30
•VCR 1 (video recorder 1) VCR 2 (video recorder 2) DVD player
HiFi (e.g. amplifier, tuner, tape, etc.) The remote control must be programm- ed with suitable codes from the code list.
☞Note the factory settings (page 6) and see the code list at the end of this manual.
1.1Entering the codes for VCR and DVD
☞After executing steps a) to c), you have about 15 seconds to make further entries. If you do not do so, the remote control returns automa- tically to the TV operating level.
a)Use the Select key to select the desired operating level. The coloured LED for the selected level lights.
b)Press and hold the keys 
and
c)Enter the appropriate code (see the code list) with the numeric keys.
If the code is accepted, the LED again blinks twice. If you enter a
1.2Entering the codes for CD player, tuner and tape
☞After executing steps a) to c), you have about 15 seconds to make further entries. If you do not do so, the remote control returns automa- tically to the TV operating level.
a)Use the Select key to select the opera- ting level HiFi. The coloured HiFi LED lights.
b)Press the 
key, release it and then press the key:
... for tuner (radio) or
... 
for tape (cassette recorder)
on the remote control until the LED blinks once.
c)Enter the appropriate code (see the code list) with the numeric keys.
If the code is accepted, the LED again blinks twice. If you enter a
8