Connecting your TV
Connecting to a computer
You can use your TV as a monitor/speakers for your computer by connecting through its 15pin standard RGB interface and PC audio interface. Connect the devices as shown below.
Computer
To speaker | To VGA |
|
RGB line
Audio line
Note: This PDP TV supports up to XGA format display(1024*768).
Connecting to an antenna
To enjoy the terrestrial signal transmitted by your local TV station, you need an indoor or outdoor antenna (not supplied). Perfect picture quality requires a good signal and generally means that an outdoor antenna must be used. The exact type and location of the antenna will depend on your particular area. Consult your local dealer or service personnel for best advice. If you are a subscriber of your local CATV net, the outdoor or indoor antenna is not needed. Connect the equipments as the following figure.
REAR VIEW
Plug(not supplied) |
|
|
|
| Coaxial Cable (75 | ) |
|
|
| The signal comes from: | |
|
| ! | An outdoor antenna |
! | An indoor antenna | ||
Adaptor (not supplied) |
| ! | CATV net |
|
| ||
Loosen the screw | Insert the feeder in | Tighten the screw | |
ANTENNA SOCKET
ANT 75 
Note: The above figures are for reference only, please refer to the actual units to determine their appearance.