Hisense Group PDP4211EU manual PDP Wall-mounting Bracket Installation Guide

Page 22

Appendix

PDP Wall-mounting Bracket Installation Guide

Read carefully before installation!

The installation guide should be retained for future reference.

Caution:

1.To avoid mistakes or hazards, do NOT attempt to install the TV by yourself. Refer all installation to qualified servicing personnel.

2.Do NOT install the TV on a sloping wall that makes the TV screen slant over 25 degrees from the vertical or it may tumble or cause injury.

3.The instructions in this guide must be followed to correctly install the TV.

4.It requires more than one person to install the TV.

5.Before installation, examine whether the wall conforms to the specifications and whether the supplied parts can be fixed to it. The wall for mounting should sustain the weight of TV and speakers, e.g. cement wall or brick wall. Do NOT attempt to install the TV on a flexible wall such as sheetrock wall or plaster wall, unless the bolts are fixed on an area with standard building rigidity which sustains the weight of the TV and speakers. If the rigidity of the wall can not be measured, every mounting hole should sustain a frontal force of over 100N and a shearing force of over 200N.

6.Use the specified electric drill and drill bit for drilling. The drilling holes should conform to the specifications.

7.To avoid fire and shock, do NOT place a radiator, heater or humidifier below the installed TV.

8.The TV should be kept away from moisture, sensors and power line. The TV should be kept away from impact and vibration.

9.Be sure that the power supply is disconnected before installation for fear of fire and shock.

Wall-mounting Installation Steps:

1.Take the brackets from the package, and check if there are serious defects (e.g. defective junctures).

2.Adjust the bracket to the desired angle. Use the bolt 5 to adjust the angle by joining the holes of column beam 2 and holes of lever 8.

3.Drill locating holes of the specified dimension in a vertical wall of concrete or brick. The hole size should be 11mm. The hole depth should accommodate the expanding tube of the bolt.

4.Fix the bolts into the drilled holes in step3, and then cover each bolt with a metal washer. Join the four mounting holes in the bracket to the four bolts in the wall, cover each bolt with a metal washer, and then fasten with a screw nut. Check its rigidity by pulling the bracket.

5.Fix the fixture disk to the back cover of the TV using four M8*40 bolts.

-20-

Image 22
Contents Part No IES050148 Contents Important Safety Instructions Fire and Shock PrecautionsLearning about your new TV Connecting A/V equipments Connecting your TVSelecting a location for the TV Plasma TV Connecting to a computer Connecting to an antennaUsing the remote control Preparing the remote control for useLearning about the remote control Understanding the TV features Using the TV featuresBasic Operations Use Recall button Adjust VolumeSelect channels by numbers Display channel numberUsing the Channel Menu Channel Edit Using the Picture MenuUsing the Sound Menu NicamLanguage Using the Clocksetup MenuUsing the Function Menu CalendarMotion Detect Teletext OperationsAdvance Reveal CancelHold SUB CodeSpecifications Cleaning and CareAppendix Appendix Troubleshooting Symptoms Possible SolutionsDesktop Quick Installation Guide If the TV is to be desktop mountedPDP Wall-mounting Bracket Installation Guide Wall-mounting Installation StepsAppendix