Panasonic AJ-SD755 operating instructions Display panel

Parts and their functions

Display panel

			1				2							3			45			7 6		8
																		SCH		SERVO
525						WIDE	REMOTE						VIDEO			AUDIO
dB			dB										Y PB PR			ANALOG			U
0			0					CUE					CMPST			AES/EBU				=	EDIT REC		INH
-4			-4				dB						SDI		USER SET			DVCPRO
-8			-8				-8									SDI
-12			-12				-12					SDTI/1394			SDTI/1394				DVCAM
													SG 1 2			SG
-16			-16				-16
-20			-20				-20
-25			-25				-25			CTL
-30			-30				-30
												TC
-			-				-
											UB
	L	R		L	R			L	R

1WIDE lamp

This lamp lights when 16:9 wide-screen information is being recorded on a tape.

Recording of wide-screen information can be selected on setup menu No. 645 (WIDE SELECT). This lights lamps during tape playback when wide- screen information has been recorded on the tape.

2REMOTE lamp

This lamp lights when the CONTROL switch has been set to the REMOTE position.

3INPUT SELECT display area

The characters corresponding to the selected input signals light. With all input signals except for analog audio signals, the fact that no signals have been

selected is indicated by a flashing display.

VIDEO
Y PB PR	: Analog component video signals
CMPST	: Analog composite video signals
SDI	: Serial digital video signals (option)
SDTI/1394	: Compressed digital signals (option)
SG/SG 1/SG 2: Internal reference signals
AUDIO
ANALOG	: Analog audio signals
AES/EBU	: Digital audio signals
USER SET	: Recording audio signal selection
SDI	: Serial digital audio signals (option)
SDTI/1394	: Compressed digital signals (option)
SG	: Internal reference signals

4U lamp

This lamp lights when UMID information is present on the input signal in E-E mode.

This lamp lights during tape playback when UMID information has been recorded on the tape.

5SCH lamp

This lamp lights when the SCH phase of the external synchronized signal (REF VIDEO) is inside the prescribed range.

At all other times, the lamp is off.

6= lamp

This lamp lights when a cassette tape is inserted into the VTR.

In the standby OFF mode, this lamp is flashing.

7SERVO lamp

This lamp lights when the drum servo or capstan servo locks.

8Channel condition lamps

These lamps light to indicate the error rate status. (green 5 white 5 red)

Green: This lights when the error rates for the video and audio playback signals are both at acceptable levels.

White : This lights when the error rate for the video or audio playback level has increased.

The playback picture and sound remain unaffected even while this lamp is lighted.

Red : This lights when the error rate for the video or audio playback level has increased to the extent that correction or interpolation was performed.

11