Panasonic AJ-D650 manual Rack mounting

Page 45

Rack mounting

The unit can be mounted into a 19-inch standard rack if the optional rack-mounting adaptors (AJ-MA75P) are used. For the installation rails, it is recommended that the rail and bracket for 18" length (model number CC3001-99-0400) of SHASSIS TRAK be used. (The complete slide rail and bracket unit is not available from Panasonic) For further details, consult with your dealer.

Remove the screws on the left and right sides of the unit.

Use the removed screw to attach the inner members of the slide rails.

The length of the screws used is subject to restriction. If some of the mounting screws have been lost or misplaced, use screws which are less than 4" long in their place. Use four screws to secure each inner member.

Attach the outer member brackets to the rack.

Check that the height is the same for the left and right brackets.

Attach the AJ-MA75P rack-mounting adaptors with included 4 screws.

Remove the 4 rubber legs from the bottom of the unit, and install the unit in the rack. After the unit has been installed, check that it moves smoothly along the rails.

<Notes>

•Keep the temperature inside the rack to between +41°F (5°C) and +104°F (40°C).

•Bolt the rack securely to the floor so that it will not topple over when the VTR is drawn out.

– 4 5 –

Image 45

Contents

Operating Instructions FCC Note Refer Servicing to Qualified Service PersonnelContents Features General and FeaturesMenu-driven setup Multi-function input/output interfacesChannel high-sound-quality digital audio Controls and their functions Front panelCounter Display Section Cassette insertion slot Power switchEject button EDIT/EDIT REC/REC/REC INH lampsCOUNTER/REMAIN button Reset buttonREW button* ¹ Stop buttonVolume control Headphones jackCTL/TC/UB switch Monitor Select switchAudio Input switch Video Input switchREMOTE/LOCAL switch SET buttonConnector area Signal GND terminal AC in connectorAnalog Audio in connectors Time Code in connectorAnalog Component Video OUT connector S1/VIDE0 OUT connectorAnalog Composite Video OUT connectors Remote connectorP e s Type Description ConsumerCassette Set the Control switch on the front panel to Local When recording/playback using 1 unitWhen recording, playback & editing with 2 units deck to deck When using an editing controller Connect the equipment as shown in the figure below Internal encoder adjustmentsWaveform on waveform monitor Printed circuit board Printed Abbr FactoryFull name Function Name Switching on the power/inserting the cassette Still Timer Setting Stop mode1Selecting video/audio input signals 2Adjusting the audio IevelRecording Playback Setup default settings Changing the settingsFollowing message is displayed Changing the file Setup setting menusSetting Description SettingSystem menu User menuDisplay TimerSTA LocalOperation Memory Auto REWStop 9P SELUser menu E D I T Edit Blank VitcThru TCGTime Code Display VideoCH2 OUT CH1 OUTMoni CH REC CH1ST1 REC CUEOutput ST2Time code/user bit Time codeUser bit Setting the internal time code Setting the external time code TC switch EXTRecording internal/external time codes Reproducing the time code/user bit Superimpose screen Operation mode Characters displayed Display positionServo reference Input signal status Reference signal Servo reference setting tablesVideo in signal REF in signal Servo reference No position During playback or special playbackAudio V Fade Function AJ-D650 only Rack mounting Condensation Video head cleaningAuto OFF mode Error messagesError No TV monitor display Descriptions VTR operation Error No Descriptions VTR operationError No Descriptions VTR operation Pin No. Signal Connector signalsSignal Pin NoSYS.SC Coarse RS-232C Remote 25-pin D-SUB straight cable supportedOther input/output connector SpecificationsPanasonic Reference Guide Contents Setting Description of setting Additional set-up menu itemsFormat SEL Introduction RS-232C interfaceExternal interface specifications For the model AJ-D750 Hardware specificationsConnector specifications Pin No Signal Circuit name DescriptionFor the models AJ-D650 and AJ-D640 Using straight cable with D-SUB 9-pin and 25-pin connectorsProtocol Software specificationsCommunication parameters NONE/ODD/EVENSend format controller PC VTR Data format Outline of send procedure from controllerWhen the communication has terminated normally Error code tableWhen the communication has terminated abnormally Return format VTR controller PCCommands relating to operation control Notes Command tableSend command Supplementary notesDV, Dvcam STX OSF ETXShtl STX OSR ETXCommands relating to inquiries Notes Print Microsoft QuickBASIC sample program