Panasonic AJ-D650 manual Error messages, Auto OFF mode, Error No Descriptions VTR operation

Error messages

Warning

Error No.	TV monitor display*	Descriptions	VTR operation
E-00*	SERVO NOT LOCKED	Error No. lights when servo disturbances continue for 3 or	Continued
(Err-00)		more seconds during playback, recording or editing.
E-01*		Error No. lights when envelope levels approx. 1/3 that of
	LOW RF	normal levels are detected for more than 1 sec. during	Stop
(Err-01)
		playback, recording or editing.
E-10*	FAN STOP	Error No. lights when a fan motor stops operating.	Stop
(Err-10)

* Displays when warning information is checked by pressing the DIAG button.

AUTO OFF mode

The following error number flashes on the counter display section.

Error No.	Descriptions	VTR operation
	When condensation is detected, the error no. display flashes, and the unit goes into
	EJECT mode. The drum rotates after the cassette tape is ejected to remove
	condensation.
	When the condensation has been removed, the error no. display disappears and the
E - 2 0	VTR may be used.	EJECT
	<Note>
	1) The drum rotates as soon as condensation is detected when the unit is in EJECT
	mode.
	2) When condensation is detected while a cassette tape is inserted, drum rotation stops,
	the cassette tape is ejected and the drum rotation begins again.
E-29	The cassette does not move up even when 6 seconds have elapsed since the VTR was
	transferred to the eject mode.	Stop
E-31	The unloading operation is not completed within 10 seconds.
		Stop
E-35	There is no response from the servo microcomputer for 1 or more seconds.
		Stop
E-36	Only the servo microcomputer was reset in an instantaneous power failure.
		Stop
E-37	The servo microcomputer does not follow the instructions of the system control
	microcomputer even when 10 seconds have elapsed.	Stop
E-51	The message display flashes when the take-up reel has been rotating idly for a fixed
	period of time while the start/end processing operation during loading (half position) is	Stop
	being performed.
E-52	After the cassette has been inserted, the tape take-up reel has not wound up the tape
	while the total tape amount is not detected and while the tape is traveling at or above	Stop
	the normal tape speed in the forward or reverse direction.
E-53	After the total tape amount has been detected, the amount of tape wound up on the
	take-up reel and the amount of tape supplied by the supply reel differ to an abnormal	Stop
	extent while the tape is traveling.
E-55	The tape has not been wound up during unloading.
		Stop

– 4 7 –