VIDEO Plus+ |
|
| TV | ||||
|
| VCR DVD | |||||
|
|
|
|
|
|
| |
| Timer recording |
|
|
| 1/3 |
| |
| Pos | Date | Start | Stop |
| PDC |
|
|
|
|
|
|
|
|
|
| - - - - - - |
| 10:30 11:30 | SP | - - - |
| |
| - - - - - - - | - | - | - | - - - |
| |
| - - - - - - - | - | - | - | - - - |
| |
| - - - - - - - | - | - | - | - - - |
| |
| - - - - - - - | - | - | - - - - |
| ||
| - - - - - - - | - | - | - - - - |
| ||
|
|
|
|
|
|
|
|
[-
Note:
VCR DVD
If [-
Pos is the Programme Position/TV Station Name.
Normally, the name of the TV station and the number of the programme position is displayed under [Pos].
However, if the TV station information was not automatically set during Auto Setup due to adverse reception conditions, the
In this case, follow the steps below to set the Pos.
Press repeatedly to select the programme position on which the TV programme to be recorded will be broadcast.
After you have entered the information of a TV station, it remains stored in the VCR’s memory, and you do not need to enter it again in the future.
To suspend the Timer recording Standby Mode
When you want to use the VCR for playback or manual recording before the programmed timer recording will be performed, you can temporarily suspend the timer recording standby mode by pressing the TIMER REC button so that the indication on the VCR display disappears.
However, after you have finished using the VCR, remember to reactivate the timer recording standby mode by pressing the TIMER REC button again, otherwise the programmed timer recording will not take place.
-VIDEO Plus+ and PlusCode are registered trademarks of Gemstar Development Corporation. The VIDEO Plus+ system is manufactured under license from Gemstar Development Corporation.
29