Pelco dx8100-exp Prepare DX8100 for Expansion Unit Installation, Open the DX8100 Chassis

Page 8

Prepare DX8100 for Expansion Unit Installation

This section describes how to access the DX8100 interior. For information about mounting the DX8100 in a rack, refer to the DX8100 Installation Manual.

OPEN THE DX8100 CHASSIS

If the DX8100 is mounted in a rack, it must be removed. Two people might be required to lift and remove the DX8100.

To move the DX8100 to an area that will provide full access to the unit chassis:

WARNING: Make sure unit is turned off and you are wearing a properly grounded ESD wrist strap before attempting to open the DX8100 chassis cover. For information about shutting down the unit, refer to Getting Ready on page 6.

1.Disconnect any cables or connections that may restrict access or interfere with the removal of the unit.

2.(If applicable) Unscrew the fasteners that are securing the unit in the rack and carefully lift the unit out of the rack.

3.Place the DX8100 on a flat surface with ample workspace.

WARNING: The chassis assembly includes parts with sharp edges. To avoid injury, use caution when working in and around the DX8100’s chassis and components.

4.Using a Phillips screwdriver, remove the chassis cover:

a.Remove the top two screws on the left and right side panels of the DX8100. Refer to Figure 5.

b.Remove the four silver screws (at top of the unit) fastening the cover to the back of the unit. Refer to Figure 6.

c.Carefully remove the chassis cover by sliding it back and up. Set aside the cover.

Figure 6. Removing Chassis Cover

8

C2636M (11/06)

Image 8
Contents DX8100-EXP Expansion Unit Installation Manual Page Introduction This document is organized into the following sectionsParts List Other DX8100 Optional Accessories Tools NeededUnplug the power cord from the wall socket Getting ReadyC2636M 11/06 Prepare DX8100 for Expansion Unit Installation Open the DX8100 ChassisComponent Layout CPUInstall the DX8100 I/O Card TV/Audio cable Video ribbon cable 32-pin DX8100 I/O cardInstalling the DX8100 I/O Card Installing the Capture Card Optional Capture Card identical to the main Pin ribbon cableInstalling the Optional Capture Card Reassemble the Unit To reassemble the DX8100Connecting the Expansion Unit to the DX8100 Item QtyInterfacing the Expansion Unit and DX8100 Power on the DX8100 Restarting the UnitPage Product Warranty and Return Information ISO9001
Related manuals
Manual 20 pages 46.03 Kb