FUNAI ZV450TT8 Antenna Cable Connection, Disconnect the power cord of your TV from the AC outlet

Page 15

ANTENNA CABLE CONNECTION

This section describes how to connect your unit to an antenna, cable box, etc.

1Disconnect the power cord of your TV from the AC outlet.

2 Disconnect RF coaxial cable from antenna input jack of your TV.

VHF / UHF

rear of your TV

antenna

1

or

ANT. IN

RF coaxial cable

disconnect

2

cable TV

company

disconnect

3Connect cables to the unit.

Make the basic connection as illustrated below.

rear of this unit

Disc Introduction Connections Basic Setup Management

								DVD/VCR
S-VIDEO								IN ---AUDIO---OUT

								L
								L
IN								R



					IN ---VIDEO---OUT

				OUT
	DVD		DVD/VCR
DIGITAL	AUDIO	S-VIDEO COMPONENT	S-VIDEO IN ---AUDIO---OUT
AUDIO OUT	OUT	VIDEO OUT
		Y	L	LIN
				ANTENNA
	L	PB	INR	R
	L	OUT /CB	INR	R
		PR	IN ---VIDEO---OUT	OUT
		/CR
				IN
				ANTENNA
rear of your TV				RF coaxial cable	RF coaxial cable
				RF coaxial cable	RF coaxial cable

VHF / UHF antenna

or

Recording

									This connection is for
RCA audio								RCA video	TV loop through only
cable								cable

cable TV company

Playback

R	L	ANT. IN
AUDIO IN		VIDEO IN

4Plug in the power cord of this unit and your TV to the AC outlet.

Editing

rear of your TV

connect

rear of this unit

DIGITAL

AUDIO OUT

COAXIAL

Supplied cables used in this connection are as follows:

•RF coaxial cable x 1

•RCA audio cable (L/R) x 1

•RCA video cable x 1

Please purchase the rest of the necessary cables at your local store.

*Once connections are completed, turn on the TV and initial setting begin.

Channel scanning is necessary for the unit to memorize all available channels in your area.

(Refer to “INITIAL SETTING” on page 24.)

Function Setup VCR Functions

Note

•For your safety and to avoid damage to the device, please unplug the RF coaxial cable from the ANTENNA IN jack before moving the unit.

•If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than set-top versions.

•RF output is for tuner pass through only. DVD playback through the RF is not possible.

EN 15

Others Español

Image 15

Contents ZV450TT8 RADIO-TV Interference PrecautionsLaser Safety Make your contribution to the environmentPrecautions Important SafeguardsMoisture Condensation Warning Installation LocationSupplied Accessories Avoid the Hazards of Electrical Shock and FireCleaning the disc lens Maintenance ServicingCleaning the cabinet Cleaning discsContents Features DVD-R FeaturesDVD-VIDEO CD-DA CD-RW Unplayable DiscsColor Systems Region CodesFunctional Overview Front Panel21 2019 18 17 13 12 11 10 Functional Overview Rear Panel11 10 Open the cover Insert batteries Remote Control Installing the Batteries in the Remote Control Using a Remote ControlDTV/TV button DVD/VCR Current status of the unit Front Panel DisplayDisplay Message DB HDDAntenna Cable Connection Disconnect the power cord of your TV from the AC outletPlug in the power cords of the devices to the AC outlet RF Modulator ConnectionSupplied cables used in this connection are as follows Introduction With this setupAudio OUT DVD Video OUT Component Video Output Connection to a TVThis unit Video OUTAudio OUT SettingConnection to AN Audio System AudioVCR mode Thevcr / DVD Recorder SwitchingFile Name Information Setup VCR Functions Others EspañolOn-Screen Display / Menu OFFGuide to ON-SCREEN Displays and Menus DVD mode Disc Information / MenuConnections Basic Setup Main MenuDisc Management Recording Playback Air Initial SettingPress Power Press Enter to activate ClockAuto Channel Scan Channel SettingUse K / L to select Auto Preset, then press Enter When scanning is over, press Setup to exitChannel Setting Use K / L to select Manual Preset, then press EnterAdding / Deleting Channels Delete Press Setup to exitPress Setup to exit and turn off the unit Setting the ClockAuto Clock Setting Use K / L to select Auto Clock Setting, then press EnterSetting the Clock Manual Clock SettingDaylight Saving Time Tuner Settings Switching Analog Mode Digital ModeChannel Selection Press Audio to cycle through available audio languages Tuner SettingsFunction Editing Setup VCR Functions Others Español Selecting TV AudioUse K / L to select Stereo or Selecting TV Audio cont’dUse K / L to select TV Audio Select, then press Enter SAP, then press EnterUse K / L to select DTV CC, then DTV Closed CaptionUse K / L to select Display, then press Enter Use K / L to select CC Style, thenThen press Enter Closed Caption StyleSwitch the setting for each item you Use K / L to select the itemWant to set, then press Enter Insert a brand-new disc. Formatting will start Formatting a DiscChoosing the Recording Format of a Brand-New DVD-RW Formatting is completed.100% is indicatedUse K / L to select Yes, then press Enter Formatting a DiscReformatting a Disc Manually Use K / L to select Format, then press EnterPreparing a Disc Setting for Auto ChapterSetting Aspect Ratio for Video Mode Recording Press Setup to exitDisc will be protected Setting a Disc to ProtectOFF ON, then press ENTER. e.g. VR mode DVD-RW To cancel the disc protectAuto Finalizing General Setting menu will appearUse K / L to select Finalize, then press Enter Press Setup Use K / L to select DVD Menu, then press EnterPlaying the Discs in Other DVD Players Finalizing a Disc42 EN Video Information on DVD RecordingRecording Speed Restrictions on RecordingIt may take awhile to load Disc completely Press OPEN/CLOSE a to close the disc trayPress REC Speed to select a recording speed Number buttons to select a desired Channel to recordPlayback Editing Disc Connections Basic Setup Management RecordingPress Stop C to stop recording Press REC/OTR to start recordingUse K / L to enter the date, then press B Timer RecordingTimer Recording To stop the timer recording in process Press T-SETWill disappear on the front panel display VCR Functions Others Español Hints for Timer RecordingPriority of Overlapped Settings Function Playback Editing SetupIf you want to use S-VIDEO in jack, select Video Settings for AN External DeviceConnection to an External Device External deviceIt takes a while to load Disc Settings for AN External DeviceRecording from an External Device Press Stop C / Stop C/EJECT a on the unit to stop recordingMake sure that the disc is recordable. Refer to Dubbing ModeUse K / L to select Dubbing Mode, then press Enter Use K / L to select Recording, then press EnterPress Stop C to stop the recording Dubbing ModePress DVD Press DubbingInformation on Playback Structure of Disc ContentsSome discs may start playback automatically Direct PlaybackUse K / L to select Play From Basic PlaybackPlayback from the Title List Press Stop C once to stop playbackPress OPEN/CLOSE a to close Follow steps 1 to 2 in DirectPlayback on Or track/file, then press EnterUsing the Title / Disc Menu PauseKodak Picture CD Skipping TV Commercials During Playback Special PlaybackResume Playback Fast Forward / Fast Reverse PlaybackSlow Forward / Slow Reverse Playback Special PlaybackRapid Playback Step by Step PlaybackMarker Setting ZoomDVD-video Title/Chapter Search Using Skip j / SkipUsing Display SearchSearch Time SearchAudio CD Random Playback Repeat PlaybackRepeat this step until you program all the desired tracks Program PlaybackYou can program the disc to play back in your desired order Large-size Jpeg files take a few moments to be displayedSwitching Audio Soundtrack Switching SubtitlesEnter Switching Virtual Surround SystemSwitching Camera Angles Reducing Block NoiseGuide to a Title List Information on Disc EditingDeleting Titles After the disc is fully recordedDisc Management Recording Title, then press Enter Deleting TitlesPress DVD first Use K / L/ s / B to select a desiredPlaylist, then press Enter CREATING/DELETING PlaylistAdding Titles to a Playlist Use K / L to select Add ToUse K / L to select Yes, then press ENTER.DVD Menu Press DVD first. Press SetupCREATING/DELETING Playlist Erasing All PlaylistPutting Names on Titles Editing DiscsPutting Names on Titles cont’d Mode automaticallyPrevious input mode automatically Editing DiscsPress Return Setting or Clearing Chapter MarksDisc Connections Basic Setup Management Recording Playback Use Skip H / GCursor will move to Preview VR mode DVD-RW playlistDeleting a Part of a Title Use K / L to select Scene Delete, then press EnterUse K / L to select Delete then press Enter Then press EnterPart of the title is deleted Dividing a Title Press DVD first Stop mode, press TOP MenuPress Return or Stop C to exit Combining Titles Combining, then press EnterOthers Press Return and then Return or Stop C to exit Setting or Releasing the Title ProtectionTo protect a whole disc VR mode DVD-RW only Confirm the indication OFF ON. Press Enter againIf you select OFF at , all the chapter marks are erased Setting or Clearing All Chapter Marks at OnceUse K / L to select Chapter Mark Use K / L to select the desired interval, then press EnterContents List of SettingsEspañol List of SettingsPress Stop C if you are playing back a disc SetupsPlayback Use K / L to select a desired item, then press EnterFunction SetupsParental Lock Default All Playback cont’dPCM Disc Menu Language Default EnglishAudio Language Default Original Audio OutSubtitle Language Default OFF Angle Icon Default onStill Mode Default Auto For When you finish with setting, press Setup to exitDisplay Refer to 1 to 5 on page 89 and set the selected itemDisplay cont’d OSD Language Default EnglishScreen Saver Default 10 minutes FL Dimmer Default BrightFor 3 , refer to Connection to an External VideoSelected item Refer 1 to 2 on page 91 and setProgressive Default OFF TV Aspect Default 43 Letter BoxVideo cont’d Reset the setting to default Reset AllSelect Yes using K / L , then press Enter Select Yes again using K / L , then press EnterPress REC/OTR to begin the recording VCR FunctionsPress VCR first Before recording, make sure Recording speedVCR Functions One-touch Timer Recording OTRYou cannot pause the one-touch timer recording Using REC/OTR or Stop COther Operations SET TroubleshootingSymptom RemedyTroubleshooting Symptom RemedyPress OPEN/CLOSE a OPEN/CLOSE a to take out the disc. The disc canceled during Repairing process MAY not workREC/OTR Error message Cause Solution Frequently Asked Questions Language Code Language CodeGlossary Tuner SpecificationsGeneral RecordingDisco simple de video VSD EspañolDiscos no Reproducibles Códigos de RegiónIntroduction Connections EspañolCon el rótulo aupntando hacia arriba Presione PowerPresione Enter para activar Ajste Manual de Reloj Presione DVDPresione Enter Presione Timer ProgConfigure una programación del Temporizador1VMN23550 Customer ServiceTel E9H11UD