FUNAI ZV450TT8 owner manual Timer Recording, Use K / L to enter the date, then press B

TIMER RECORDING

You can program the unit to record up to 12 programs within a month in advance. Daily or weekly program recordings are also available.

Before recording, make sure

•Set the clock before setting a timer programming.

•Insert a recordable disc with enough recordable space or a cassette tape with an erase-protection tab.

POWER	INPUT	DTV / TV	OPEN/CLOSE
	SELECT
.@/:	ABC	DEF
1	2	3
GHI	JKL	MNO	CH
4	5	6
PQRS	TUV	WXYZ	DISPLAY
7	8	9
	SPACE	CLEAR	SETUP
	0
TOP MENU MENU/LIST		RETURN	ENTER

VCR DVD

AUDIOPLAY

REC SPEED	SKIP	PAUSE	SKIP
TIMER PROG. CM SKIP		STOP	X1.3/0.8

REC/OTR DUBBING T-SETSEARCH

Note

•If you have not set the clock yet:

“Clock Setting” menu will appear instead of the timer programming list at step 1. Continue with the step 3 in “Manual Clock Setting” on page 29 before setting a timer programming.

•Use [s / B] to move the cursor to the left and the right in “Timer Programming” menu.

•If a basic recording or one-touch timer recording is in progress on one component (e.g., VCR) and the timer recording set for the other component (e.g., DVD) is about to begin, the unit automatically switches to the programmed channel for timer recording 2 minutes before the programmed starting time, and the recording in progress (for VCR) will be canceled UNLESS their recording channels are the same. If their recording channels are the same, the timer recording will start without canceling the recording currently in progress. In this case, the recording of the same channel will be made on both DVD and VCR.

•Cancel the timer-standby mode by pressing

[T-SET]before operation for either DVD or VCR. When finished operating, press [T-SET]to resume the timer-standby mode.

•In the timer-standby mode, you can turn on the power and use the component (VCR or DVD) which is not currently timer-programmed.

Guide to Timer Programming Display

3		1	2
Timer Programming
JAN/ 2/07 12:00 AM 125-1 SP
2H (1:00)		MON JAN/01 10:00AM
Date	Start	End	CH
JAN/02	12:00AM 1:00AM DTV 125- 1
	New Program
			1/1
4			5

1.Title of a timer program (Contains date, time, channel, recording speed of the program)

2.Current date and time

3.Recording speed and length of the recording

4.Timer program list

5.Total number of pages and current page (2 pages maximum)

1Press [TIMER PROG.].

2Use [K / L] to select “New Program”, then press [ENTER].

Timer Programming

MON JAN/01 10:00AM

Date Start End CH

New Program

1/1

•If there are 6 or more programs, use [SKIP H / G] to change pages.

3Use [K / L] to enter the date, then press [B].

Date		Start		End
JAN/02	- - : - -			- - : - -
CH		REC To	Speed
DTV125- 1		DVD		2H
			2H	2	: 00

JAN/01	When pressing [L] at
	the current date, the
Daily
	date will change as
MON-SAT
	follows.
MON-FRI	e.g.) January 1st
SAT
FRI
SUN
JAN/31

46 EN