JVC HR-J245EK, HR-J645ES, HR-J645EK, HR-J246EK Safety Precautions, Do not place the recorder

Page 2

2

SAFETYFIRST

Safety Precautions

The rating plate and the safety caution are on the rear of the unit.

WARNING: DANGEROUS VOLTAGE INSIDE

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.

IMPORTANT

Connection to the mains supply in the United Kingdom. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain a proper safety approved extension lead/adapter or consult your dealer.

BE SURE to replace the fuse only with an identical approved type, as originally fitted, and to replace the fuse cover.

If nonetheless the mains plug is cut off remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply.

If this product is not supplied fitted with a mains plug then follow the instructions given below:

DO NOT make any connection to the Larger Terminal coded E or Green.

The wires in the mains lead are coloured in accordance with the following code:

Blue to N (Neutral) or Black

Brown to L (Live) or Red

If these colours do not correspond with the terminal identifications of your plug, connect as follows:

Blue wire to terminal coded N (Neutral) or coloured Black. Brown wire to terminal coded L (Live) or coloured Red.

If in doubt — consult a competent electrician.

CAUTION

When you are not using the recorder for a long period of time, it is recommended that you disconnect the power cord from the mains outlet.

Dangerous voltage inside. Refer internal servicing to qualified service personnel. To prevent electric shock or fire hazard, remove the power cord from the mains outlet prior to connecting or disconnecting any signal lead or aerial.

IMPORTANT

Please read the various precautions on p. 2 – 3 of this instruction manual before installing or operating the recorder.

It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs without the consent of the owner of copyright in the sound or video record- ing, broadcast or cable programme and in any literary, dramatic, musical, or artistic work embodied therein.

The STANDBY/ON button does not completely shut off mains power from the unit, but switches operating

current on and off. " " shows electrical power standby and " " shows ON.

Video tapes recorded with this video recorder in the LP (Long Play) mode cannot be played back on a single-speed video recorder.

Failure to heed the following precautions may result in damage to the recorder, remote control or video cassette.

1. DO NOT place the recorder . . .

... in an environment prone to extreme temperatures or humidity.

... in direct sunlight.

... in a dusty environment.

... in an environment where strong magnetic fields are generated.

... on a surface that is unstable or subject to vibration.

2.DO NOT block the recorder’s ventilation openings.

3.DO NOT place heavy objects on the recorder or remote control.

4.DO NOT place anything which might spill on top of the recorder or remote control.

5.AVOID violent shocks to the recorder during transport.

TM

PAL

Only cassettes marked "VHS" can be used with this videorecorder.

HQ VHS is compatible with existing VHS equipment.

Video Plus+ and PlusCode are trademarks of Gemstar Development Corporation. The Video Plus+ system is manufactured under license from Gemstar Development Corporation.

MOISTURE CONDENSATION

Moisture in the air will condense on the recorder when you move it from a cold place to a warm place, or under extremely humid conditions—just as water droplets form in the surface of a glass filled with cold liquid. Moisture condensation on the head drum will cause damage to the tape. In conditions where condensation may occur, keep the recorder turned on for a few hours to let the moisture dry.

ABOUT HEAD CLEANING

Accumulation of dirt and other particles on the video heads may cause the playback picture to become blurred or inter- rupted. Be sure to contact your nearest JVC dealer if such troubles occur.

Image 2
Contents Instructions Safety Precautions Do not place the recorderStep Quick SET UP Situate Recorder Check ContentsBasic Connections Connect Recorder to MainsBack of HR-J645EK/ES Back of HR-J245EK/J246EKVideo Channel Set With RF ConnectionSET Video Channel Access Video Channel SET ModeExit Video Channel SET Mode With AV ConnectionAuto Set Up Perform Auto SET UPIf auto channel set has succeeded but auto clock set has not Access Main Menu Video Plus+ SetupMake List of Stored Station Names Preset Positions ScreenClose Menu Confirm Preset Position NumberWhen Using a Satellite Receiver And/Or Cable System BackPoint Basic PlaybackLoad a Cassette Start PlaybackActivate HIGH-SPEED Search Playback FeaturesSearch PlaybackManually Adjust TrackingOverride Automatic Tracking Return to AutomaticActivate Counter Activate Index SearchSET Counter Memory MemorySoundtrack Selection HR-J645EK/ES only Activate RepeatRepeat Playback Next Function Memory Ntsc PlaybackBasic Recording Recording Features Recording S.T. Picture SystemReturn to Normal Playback Video Plus+ Timer Recording PDC RecordingIf your recorder receives Press OK after enteringStart Time Regular Timer ProgrammingAccess Programme TimePress TV PROG. + Timer ModeEngage RECORDER’S Revise Programme Check And Cancel ProgrammesTimer Warning InformationAccess Main Menu Screen Auto TimerMake Connections SET Recording DECK’S Input ModeEdit To Or From Another Video Recorder Start Source PlayerRecorder HR-J245EK/J246EKPlayer Recorder PlayerStart Camcorder SET RECORDER’S Input ModeEdit From a Camcorder Start RecorderConnection To Stereo System HR-J645EK/ES only Connection To a Satellite Receiver Satellite Receiver UnitPin Scart connectors Aerial terminal On-Screen Dispiay Access Mode SET ScreenTurn on the Recorder 13 3Tape Position Indicator Type of Broadcast On-screen Display Being ReceivedAuto Channel Set Perform Auto Channel SETStations your recorder Preset positions PRProcedures Located appear on aManual Channel Set Delete Channel Change Station Preset PositionSelect Item Select NEW PositionSelect Station Name Character Switch StationsSelect NEW Station Enter NEW CharacterSelect Channel to Perform TuningFine-Tuning Channels Already Stored FINE-TUNETV Station And ID List Station NameTV Station Channel Number Guide For customers in the U.K ScotlandPreparation Clock SetTurn the Recorder on SET Date and Time PresetSET Clock SET Just ClockTroubleshooting Timer Recording Timer againQuestions and Answers Specifications Index Rear View J645EK/ES Display Panel Remote Control Operating JVC TVs Installing BatteriesHow To Use Memo Victor Company of JAPAN, Limited