9
Auto Set Up results appear on the display panel
● When both auto channel set and auto clock set have been completed successfully the correct current time will be displayed.
● When auto channel set has been completed successfully but auto clock set has not, "CH" will be displayed.
● When neither auto channel set nor auto clock set has been completed successfully,
* See "Video Plus+ Setup" on page 10 to check if the Guide Program numbers have been set correctly.
If both auto channel set and auto clock set have been performed successfully:
1 Turn on the TV and select its VIDEO channel or AV mode, then make sure that all necessary stations have been stored in the recorder's memory by using the TV PROG. button(s).
●If station names (ID — ☞ pg. 42) have also been stored in the recorder's memory, the station name will be displayed at the top left corner of the screen for about 5 seconds when the recorder is tuned to a different station.
●If you want to set the tuner manually such as to add or skip channels, to change preset positions, or to set or change station names, see pages 38 – 41.
2 Perform "Video Plus+ Setup" on page 10 to check if the Guide Program numbers have been set correctly.
If auto channel set has succeeded but auto clock set has not:
1 Turn on the TV and select its VIDEO channel or AV mode, then make sure that all necessary stations have been stored in the recorder's memory by using the TV PROG. button(s).
●If station names (ID — ☞ pg. 42) have also been stored in the recorder's memory, the station name will be displayed at the top left corner of the screen for about 5 seconds when the recorder is tuned to a different station.
●If you want to set the tuner manually such as to add or skip channels, to change preset positions, or to set or change station names, see pages 38 – 41.
2 Perform "Clock Set" on page 44, then "Video Plus+ Setup" on page 10 to check if the Guide Program numbers have been set correctly.
If both auto channel set and auto clock set have failed:
1 Make sure the TV aerial cable is connected properly to the recorder and turn off the recorder power once, then turn the recorder power back on again.
●The recorder will try Auto Set Up again.
IMPORTANT
●Depending on the reception conditions, the station names may not be stored correctly, and auto Guide Program Number Set may not work properly. If the Guide Program numbers are not set properly, Video Plus+ timer recording (☞ pg. 22) will not work correctly; be sure to check if the Guide Program numbers have been set correctly
(☞ pg.10, "Video Plus+ Setup").
●Since your video recorder memorizes all detected stations even if the reception condition is poor, some of those stored stations may produce a noisy picture. To delete those stations, ☞ "Delete A Channel" on page 39.