JVC HR-J245EK, HR-J645ES, HR-J645EK, HR-J246EK Video Channel Set, With RF Connection

6INITIALSETTINGS

Video Channel Set

Video Channel (RF Output Channel) is the channel on which your TV receives picture and sound signals from the video recorder through the RF cable.

If you have connected the video recorder to your TV via the provided RF cable only (RF connection) – Go to "With RF Connection" below.

If you have connected the video recorder to your TV via both the provided RF cable and a 21-pin SCART cable (AV connection) – Go to "With AV Connection" on next page.

IMPORTANT:

Before performing the following steps, make sure the recorder's power is off and there is no cassette inserted in the recorder.

4

¢	¢
q

Á 1

	PROG.+/–	STOP
2		1
	TV

4

1 2 3

4 5 6

7/ 8 9

0 4

2

TV PROG. 2

1 3 Á

¦ 7 8

1	4	¢
	3

3 OK

TEST SIGNAL

The channel on which the screen to the left appear clearly in step 2 is your Video Channel.

To view picture signals from the video recorder, set your TV to the Video Channel.

With RF Connection

	ACCESS VIDEO CHANNEL SET
	MODE
	Hold down STOP on the recorder until the display
1		panel shows the following.
2	SET VIDEO CHANNEL
	Set your TV to UHF channel 52.
	● If the two vertical white bars appear clearly on the
		screen as shown in the illustration at bottom left, go
		to step 3.
	● If the two vertical white bars do not appear clearly,
		press TV PROG.+ or – to set the video recorder to a
		vacant channel between 22 and 69 which is not
		occupied by any local station in your area.
		(Ex.) If channel 36 is available in your area

Then set your TV to UHF channel 36 and check if the two vertical white bars appear clearly on the screen; if so, go to step 3. If not, re-set the video recorder to another vacant channel and try again.

NOTES:

●If you set the video recorder to a channel which is occupied by a local station or has neighbouring channels that are occupied by local stations, the picture reception quality will be affected and some interference noise will appear on the TV screen. Be sure to select a vacant channel which has no broadcast on neighbouring channels.

●If you cannot obtain the two vertical white bars clearly with any channel between 22 and 69, consult your JVC dealer.

EXIT VIDEO CHANNEL SET MODE

3	Press OK.
4	TURN OFF THE RECORDER
	Press	.

After you finish this step, go to "Auto Set Up" on page 8.