VCR
|
|
|
| – |
|
| 1 | 2 | SAT |
| |
NUMBER "1" | 3 |
| |||
|
|
| 2 | NUMBER | |
| 4 | 5 | 6 | ||
|
| ||||
|
| "2" | 8 | 9 |
|
| 7 |
| |||
| NUMBER |
| 0 | 4 |
|
|
|
|
| ||
1
STOP
3
TV PROG+/– 
Remote A/B Code Switching
The remote control is capable of controlling two JVC video recorders independently; one set to respond to the remote control’s A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your video recorder is initially set to respond to A code signals. You can easily modify your video recorder to respond to B code signals.
REMOVE POWER SUPPLY
1 Unplug the mains power cord from the mains outlet.
SET REMOTE CONTROL CODE
2 While holding down VCR on the remote control, press the NUMBER key "2" and then press STOP.
RE-SUPPLY POWER
3 Plug the mains power cord back into the mains outlet.
TURN THE RECORDER ON
4 Press 
on the remote control. The recorder will now only respond to B code signals.
NOTES:
●Some TV sets may malfunction in response to the B code. If this happens, switch back to the A code.
●To set the recorder back to respond to A code signals, repeat the same procedure as shown above except pressing NUMBER key "1" instead of "2" in step 2.
27
Satellite Receiver Multi-
Brand Remote Control
Your remote control can operate the basic functions of your satellite receiver set. In addition to JVC satellite receivers, other manufacturer’s satellite receivers can also be controlled.
Before you start . . .
●Turn on the satellite receiver using its remote control.
SET SATELLITE RECEIVER
BRAND CODE
1 Refer to the chart below. While holding down SAT on the recorder's remote control, enter your satellite receiver’s brand code using the NUMBER keys, then press STOP.
Check if the satellite receiver's power goes off as it should. If it does, try other operations (☞ step 2)
●Once you have set the remote control to operate the satellite receiver, you don't have to repeat this step until you replace your remote control's battteries.
●Some satellite receiver brands have more than one code. If the satellite receiver does not function with one code, try entering another.
OPERATE SATELLITE
RECEIVER
2 | First, press SAT to set the remote control to satellite |
receiver mode, then press the corresponding button: | |
, TV PROG |
●For VIDEOWAY or some brands of satellite receiver,
you must press 
after having pressed the NUMBER keys.
●The NUMBER buttons may not function with some satellite receivers.
IMPORTANT
Although the provided remote control unit is compatible with JVC satellite receivers, as well as many other models, it may not work with your satellite receiver, or in some instances, may have limited function capability.
SATELLITE RECEIVER BRAND | CODE |
|
|
JVC | 13, 14 |
AMSTRAD | 01, 02, 03, 04 |
GRUNDIG | 05, 06 |
HIRSCHMANN | 05 |
SIEMENS | 05 |
WISI | 05 |
KATHREIN | 05, 11, 12 |
PACE | 06, 08 |
PHILIPS | 07 |
FINLUX | 09 |
ITT | 09 |
NOKIA | 09 |
SALORA | 09 |
RFT | 10 |
SKYMASTER | 10 |
MASPRO | 11 |
BT | 13 |
PANASONIC | 15 |
JERROLD | 16 |
VIDEOWAY | 17 |
|
|