JVC HR-S9500U manual Edit To Or From Another

56EN

EDITING(cont.)

You can use your VCR as the player or the recorder.

Edit To Or

From Another

VCR

Player VIDEO OUT Your VCR

S VIDEO OUT	AUDIO
	OUT

Audio/Video cable

S-Video cable(supplied) (supplied)

S VIDEO IN AUDIO IN

Recorder VIDEO IN Another VCR

Advantages Of S-VHS Editing

S-VHS allows you make high resolution video recordings when dubbing from one VCR to another.

You can edit from VHS to S-VHS, from S-VHS to VHS, or from S-VHS to S-VHS.

●From VHS to S-VHS: Record VHS playback signals in the S- VHS mode. Although the picture quality is inherently limited by the orignal VHS source material, the edited tape has better picture quality than those made by VHS-to-VHS editing.

●From S-VHS to VHS: Because the picture quality of the source material is very high, the edited tape has better picture quality than those made by VHS-to-VHS editing.

●From S-VHS to S-VHS: A high resolution copy is made of a high resolution original S-VHS tape with minimal picture degradation. This is the preferred method of video dubbing.

1		MAKE CONNECTIONS
		Connect an AV cable between the player’s VIDEO OUT
		and AUDIO OUT connectors and the recorder’s VIDEO
		IN and AUDIO IN connectors.
		● If using another VCR with an S-VIDEO input or
		output connector, it is recommended to use the S-
		VIDEO connection to minimize picture degradation
		while editing.
		● When using your VCR as the recorder and a monaural
		VCR as the player, connect the player’s AUDIO OUT
		connector to the AUDIO IN L connector on the recorder.
2		LOAD CASSETTES
		Insert the playback cassette into the player and the
		cassette to be recorded on into the recorder.
		SET RECORDER’S INPUT
3		MODE
		Set to "AUX". With this VCR, press the NUMBER key "0"
	and/or CH to select depending on the connector being
	used – "L-1" for the rear AUDIO/VIDEO IN connector,
	or "F-1" for the front AUDIO/VIDEO IN connector.
		NOTE:
		If you use your VCR as the recorder and have connected
		another VCR to your VCR's S-VIDEO IN connector, you
		need to set "REAR AUX INPUT" to "S-VIDEO" at the
		Function screen. Follow steps 4 – 6 from the "Edit From
		A Camcorder" section (☞ pg. 54 – 55).
		ENGAGE TAPE DUBBING
4		MODE
		Follow steps 12 – 14 from the "Edit From A Camcorder"
		section (☞ pg. 55).
5		START PLAYER
		Set to its play mode.
		NOTE:
		If the player is equipped with a superimpose/OSD
		disable feature then set "SUPERIMPOSE" to OFF before
		pressing PLAY (☞ pg. 29).
6		START RECORDER
		Set to its record mode.

NOTES:

●Be sure to set "TAPE DUB MODE" back to "OFF" when you finish editing.

●When "TAPE DUB MODE" is set to "ON" Active Video Calibration is deactivated in order to provide better picture quality edits.

●If you use an auxiliary input to connect a cable box or DBS receiver make sure that the correct input ("L-1", "F-1" or "S- VIDEO") is selected after you have finished editing (☞ step 6, page 54).