System Connections, Make Connections | JVC HR-S6960AA, LPT0799-001A

You can use your video recorder as the source player or the recording deck.

AMake connections

Connect the player's AUDIO/VIDEO OUT connector to the recorder's AUDIO/VIDEO IN connector.

●Use the L connector for monaural connection.

BSet recording deck’s input mode

Set to AUX. With this video recorder, press number key “0” and/or PR +/– to select depending on the connector being used — "L-1" for the rear panel VIDEO/AUDIO input connectors, or “F-1” for the front panel VIDEO/AUDIO input connectors.

CSelect “EDIT” for picture control set mode

Follow the “Picture Control” section on page 15, then select “EDIT.”

DStart source player

Engage its Play mode.

System Connections

Connecting/Using a Stereo System

These instructions enable you to connect your video recorder to your Hi-Fi stereo system (if you have one) and listen to the soundtrack through the stereo.

FM Tuner

CD Player

Stereo Amplifier

AUX IN or TAPE MONITOR

ESet recording deck

Engage its Record mode.

NOTES:

● To edit, both the player and the recorder must be of the same

colour system. Select the appropriate colour system ( 16).

● When you use this recorder as the player for editing, be sure to

set “O.S.D.” to “OFF” before starting ( 16).

● All necessary cables can be obtained from your dealer.

● NTSC tapes being played back in the "NTSC]PAL" mode

( 16) cannot be dubbed to another recorder.

● When you dub an NTSC tape using your recorder as the

playback deck, select "NTSC 3.58" (or "NTSC 4.43") for "NTSC"

setting ( 16).

● When you select “EDIT” to dub tapes, be sure to select “AUTO”

(or “NORM” when the B.E.S.T. function is set to “OFF”) after

Speaker Television Speaker

Mains outlet

Audio Cable (not provided)

(MONO)

Rear View

AUDIO OUT

you finish dubbing the tapes ( 15).

● If you are using another recorder with S-Video and Audio input/

output connectors, you can connect those connectors to this

recorder's S-VIDEO IN/S VIDEO OUT and AUDIO IN/OUT

connectors.

When Using Your Video Recorder As The Source Player ...

... connect its rear panel S VIDEO OUT and AUDIO OUT

connectors to the recording deck's S-Video and Audio input

connectors.

When Using Your Video Recorder As The Recording Deck ...

... connect its front panel S-VIDEO and AUDIO input

connectors to the source player's S-Video and Audio output

connectors. Then, set the recorder's input mode to “S-1”.

Make Connections

Connect the AUDIO OUT L and R connectors on your video recorder to the AUX IN or TAPE MONITOR terminals on your stereo system's receiver or amplifier.

NOTES:

●When connecting your recorder's audio output connectors to a stereo amplifier, make sure you connect L and R correctly.

●If stereo or bilingual TV broadcasts are receivable in your area, this recorder can record them independently of the TV set and play them back through the connected stereo system.

●When listening to sound through the connected stereo system, turn the TV's volume down completely.

CAUTIONS

●This recorder has a dynamic range of more than 80 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

●Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the video playback picture.

— 21 —