JVC HR-S7300U manual Recording, Timer again

								59
RECORDING
		SYMPTOM			POSSIBLE CAUSE		CORRECTIVE ACTION
1.	Recording won’t start.			● There’s no cassette loaded.		Insert a cassette.
				● The loaded cassette has had its		Remove the cassette and cover the
				record safety tab removed.		hole with adhesive tape, or load a
						cassette on which the record safety
						tab is intact.
2. TV broadcasts won’t record				● The VCR has been set to its AUX		Set the VCR to the appropriate
	properly.			mode by mistake.		channel.
3. Tape-to-tape editing won’t work.				●The VCRs or the camcorder and the		Refer to the directions and the
				VCR have been incorrectly con-		illustration under “Edit To Or From
				nected.		Another VCR” (☞ pg. 48) or “Edit
						From A Camcorder” (☞ pg. 46) and
						properly connect the units.
				● The power to one or more of the		Make sure the power to all units is on.
				units has not been turned on.
				● The recorder’s input mode has been		Make sure nothing is connected to
				set incorrectly.		the front panel connectors if using a
						rear panel input connection.
TIMER RECORDING
		SYMPTOM			POSSIBLE CAUSE		CORRECTIVE ACTION
1. Timer recording won’t work.			● The clock and/or the timer have			Check or re-perform the clock/timer
				been set incorrectly.		settings to ensure correctness.
			● The timer is not engaged.			Press TIMER and check to make sure
						that TIMER appears on the front
						display panel.
			● The VCR has not been set up properly.			Re-perform the set-up procedures.
						Make sure you have compensated for
						Guide Channel and VCR or cable
						box channel number mismatches
						(☞ pg. 20).
2.	On-screen timer programming		● Timer recording is in progress.			Timer programming can’t be performed
	won’t work.					when timer recording is in progress.
						Wait until it finishes.
3. TIMER and ]on the front			● The timer is engaged but there’s no			Load a cassette with the record safety
	display panel won’t stop blinking.			cassette loaded.		tab intact, or with the hole covered
						with adhesive tape.
4. The cassette is automatically			● The loaded cassette has had its			Remove the cassette and cover its
	ejected, and TIMER and ] on the			record safety tab removed.		hole with adhesive tape, or replace it
	front display panel won’t stop					with a cassette on which the safety
	blinking.					tab is intact.
5.	TIMER blinks for 10 seconds and		● TIMER has been pressed when there			Check the programmed data and re-
	the timer mode is disengaged.			are no programs in memory, or the		program as necessary, then press
				timer record program information		TIMER again.
				has not been programmed correctly.
6. The cassette is automatically			● The end of tape was reached during			The program may not have been
	ejected, the power shuts off and			timer recording.		recorded in its entirety. Next time
	TIMER and ]won’t stop					make sure you have enough time on
	blinking.					the tape to record the entire program.
7. Cable channels are not automatically			● The Cable Box Controller is not			Connect the Cable Box Controller
	switched during timer recording.			properly connected to the VCR.		correctly (☞ pg. 16).
			● The output channel selected in the			After confirming your cable box’s
				Cable Box Output screen is incorrect.		output channel number, re-access the
						Cable Box Output screen and select
						the correct number (☞ pg. 18).
			● The cable box’s power is off.			Make sure the power is on before
						timer recording starts.

CONTINUED ON NEXT PAGE.