JVC HR-S7711EU, HR-S7700EU, HR-S7722EU 50 EN, Auto Splp Timer, Digital 3R, Power Save, For Example

50 EN	SUBSIDIARY SETTINGS (cont.)
	* The default setting is bold in the table below.
8 AUTO SP]LP TIMER	When this function is set to “ON”, the recorder
ON	automatically switches to LP mode to allow complete
OFF	recording if there is not enough tape to record the entire
	programme while timer-recording in SP mode.
	For Example . . .
	Recording a programme of 210 minutes in length onto a
	180-minute tape
	Approximately 150 minutes	Approximately 60 minutes
	SP mode	LP mode
	Total 210	minutes
	Make sure you set this function to “ON”, before the timer-
	recording starts.
	NOTES:
	● If you have programmed the recorder to timer-record 2 or more
	programmes, the second programme and those thereafter may
	not fit on the tape if you set “AUTO SP]LP TIMER” to “ON”. In
	this case, make sure the mode is not engaged, then set the tape
	speed manually during timer programming.
	● In order to ensure that the recording fits on the tape, this feature
	may leave a slight non-recorded section at the end of the tape.
	● There may be some noise and sound disturbance at the point on
	the tape where the recorder switches from SP to LP mode.
	● The Auto SP]LP Timer feature is not available during ITR
	(Instant Timer Recording), and the feature will not work properly
	with any tapes longer than E-180, or with some tapes of shorter
	lengths.
	● If you perform timer recording with both VPS/PDC and the Auto
	SP]LP Timer activated, and the programme goes beyond its
	originally scheduled length, there may be times when the
	programme cannot be recorded in its entirety.
8 DIGITAL 3R	When this function is set to “ON”, the Digital 3R picture
ON	system applies edge correction to the luminance signal to
OFF	enhance detail.
	NOTES:
	● Normally it is recommended to keep “DIGITAL 3R” set to
	“ON”.
	● Depending on the type of tape being used, picture quality may
	be better with “DIGITAL 3R” set to “OFF”.
	● If you use the recorder as the source player for editing, be sure
	to set “DIGITAL 3R” to “OFF” before starting.
8 POWER SAVE	When this function is set to “ON”, you can reduce the
ON	power consumption while the recorder is turned off.
OFF	NOTES:
	● During Power Save mode ...
	... the front display panel will be turned off.
	... the Just Clock function ( pg. 60) does not work.
	... the picture may be distorted momentarily when you turn on/
	off the recorder.
	● Power Save does not work when ...
	... the recorder is in the Timer mode.
	... the recorder’s power is turned off after timer-recording or
	Instant Timer Recording.
	... the Automatic Satellite Programme Recording mode is
	engaged ( pg. 34).
	... “L-2 SELECT” is set to “DECODER” or “SAT” ( pg. 37).