JVC HR-S9400EE Locate EDIT-IN Point, Locate EDIT-OUT Point, Start R.A. Edit, To Make Corrections

[MENU] : EXIT

IN/OUT		START	JOG	8
			8
•• • • • ••	•• • • • ••
• • • •	• •	• •
				TIME SCAN SHUTTLE

EN47

LOCATE EDIT-IN POINT

Find the point on the source
		=		1
tape from where you want
			2
the edited scene to begin by	3
pressing PUSH JOGÞ%or	4
	5
using the TIME SCAN	6
SHUTTLE ring or the JOG	7
dial, then press IN/OUT.	8
	0:00:00
	(+) 0:00:00

● The edit-in point is registered in memory and appears on the screen.

● You can also perform an Index Search (if index marks have been previously recorded on the tape at the desired points) to find the points you want, but this will result in reduced accuracy.

LOCATE EDIT-OUT POINT

9

3

1

PUSH JOG

Find the point where you want the edited scene to end by pressing PUSH JOG Þ %or using the TIME SCAN SHUTTLE ring or the JOG dial, then press

IN/OUT.

● The edit-out point is registered in memory and appears on the screen.

● The total time of the edited scenes is displayed to the right of "(+)".

● Repeat steps 8 and 9 for each additional scene.

=1 0:02:23 2

3

4

5

6

7

8

0:02:23

(+) 0:00:00

[MENU] : EXIT

=1 0:02:23 0:02:51 2

3

4

5

6

7

8

0:02:51

(+) 0:00:28

[MENU] : EXIT

To Make Corrections . . .	10
. . . during step 8 or 9, you can cancel registered in and out
points by pressing CANCEL on the remote control. Each time
you press, the preceding point is erased.	11
● If, for example, you have registered 5 sets of in and out points
and want to reset the first set, you have to press CANCEL until
all points after the first set have been erased. Reenter them
after you've repaired the first set of points.

PREPARE RECORDING DECK

Engage its Record-Standby mode.

START R.A. EDIT

Press START.

● Automatic editing begins; all the specified scenes are

copied to the recording deck in the order they were

registered.

● The on-screen display remains while your recorder

searches for each scene (blinking cursor indicates

Memory Capacity

Random Assemble Editing shares memory space with the recorder's timer. If there are programs occupied by timer-recording data, those spaces cannot be used to register edit-in and -out points — meaning you won't be able to edit 8 scenes.

PROGRAM FULL

0:00:00

(+) 0:00:00

[MENU] : EXIT

scene currently being searched for), but disappears

during actual editing.

● During scene search, the recording deck automati-

cally enters its Record-Standby mode.

● When all registered scenes have been edited, your

recorder enters the Pause mode, the recording deck

enters its Record-Standby mode, and the cursor blinks

at the next available number

● When all 8 programs are full,	CONTINUED ON NEXT PAGE.
"PROGRAM FULL" appears on the R.A. EDIT screen.
● To cancel a program, see page 34.