JVC Tape-To-Tape Editing, Recorded tape HR-J277MS/HR-J271MS, Playback equipment, Dubbed tape

EN33

Playback

This recorder can play back all 3 types of recorded tape.

Recorded tape		HR-J277MS/HR-J271MS
PAL	Playback circuit
	PAL			Multi-system receiver
MESECAM				PAL
	MESECAM	Built-in		(B/G, D/K, I, H)
			RF OUT	NTSC (M)
		RFconverter
NTSC	NTSC[PAL	K, I, G, H
	NTSC 3.58 MHz
				Multi-system monitor
	Manual switching
Manual switching				PAL
	NTSC 4.43 MHz		VIDEO OUT	SECAM
				NTSC 3.58
			AUDIO OUT	NTSC 4.43

NOTES:

When viewing NTSC tapes on a PAL TV set:

●The picture may shrink vertically with black bars appearing at the top and bottom of the screen. This is not a malfunction on the part of the video recorder nor the TV.

●The picture may roll up or down. This can be corrected using the V-HOLD control found on some TVs. (This cannot be corrected if the TV does not have a V-HOLD control.)

●During search, still, or frame-by-frame playback, the picture will be distorted, and there may be a loss of colour.

ATTENTION:

When this recorder is connected to a multi-system TV, the audio signal may not be heard or may be noisy if the colour system select switch of the TV is adjusted to the AUTO position. In such a case, set the TV's colour system select switch to the appropri- ate position which corresponds to the TV system you have selected at the TV System Select screen.

Tape-To-Tape Editing

There are 4 different types of recorded tape, depending on the signal recorded.

Recorded tape

PAL

MESECAM

SECAM

NTSC

Playback equipment

PAL

MESECAM

SECAM

NTSC 3.58 MHz

NTSC 4.43 MHz

HR-J277MS/HR-J271MS

PAL

MESECAM

Recording circuit

NTSC 3.58 MHz

NTSC 4.43 MHz

Dubbed tape

PAL

MESECAM

NTSC