JVC HR-J271MS, HR-J277MS Video Channel Set, Access Video Channel SET Mode, Select TV System

4ENINITIALSETTINGS

Video Channel Set

Video Channel (RF Output Channel) is the channel on which your TV receives picture and sound signals from the video recorder through the RF cable.

If you have connected the video recorder to your TV via the provided RF cable only (RF connection) – Go to "With RF Connection" below.

If you have connected the video recorder to your TV via both the provided RF cable and an AV cable (AV connection) – Go to "With AV Connection" on next page.

With RF Connection

IMPORTANT:

Before performing the following steps, make sure the recorder's power is off and there is no cassette inserted in the recorder.

PR +/–

STOP/EJECT

1 2 3

2

4 5 6

7 8 9

4

0

PR +/–

1

OK

1

2

ACCESS VIDEO CHANNEL SET MODE

Hold down STOP/EJECT on the recorder until the display panel shows the following.

SELECT TV SYSTEM

Press PR + or – to set appropriate TV system that matches the system of TV being used (refer to the table below).

1 : B/G 2 : D/K 3 : I	4 : H
Major Countries/Areas		TV System
New Zealand, Kuwait, U.A.E.,
Indonesia, Singapore, Thailand,		B/G
Malaysia, Iran, Saudi Arabia,
Egypt, Morocco, Lebanon, Iraq
China, Mongolia, Russia		D/K
Hong Kong		I
Australia		H

TEST SIGNAL

The channel on which the screen to the left appear clearly in step 3 is your Video Channel.

To view picture signals from the video recorder, set your TV to the Video Channel.