Magnavox VR602BMG, VR402BMG owner manual Remote Control Buttons

Page 18

18 Remote Control Buttons

POWER Button

Press to turn on or off the VCR.

Number Buttons Press to select channels at the VCR. Use to set up VCR features (such as the clock).

Cable Users

Enter channel numbers as a two-digit number for the quickest results. For example, to select channel 6, press 0,6. If you only press the Number 6 button, channel 6 will be selected after a brief delay. (There also may be a brief delay when you select channels 10, 11, and 12.) If you want to select channels 100 and above, enter channel numbers as a three-digit number. For example, to select channel 117, press 1, 1, 7.

Antenna Users

Enter channel numbers as a two-digit number for the quickest results. For example, to select channel 5, press 0,5. If you only press the Number 5 button, channel 5 will be selected after a brief delay. You may only select channels 2-69.

SPEED Button

Press to select the recording speed (SP or SLP). Details are on pages 30 and 44.

TIME SEARCH Button Press to fast forward or rewind the tape a specific length of time.

Details are on page 35.

MENU Button

Press to access the VCR menu.

REWIND/{ Button When tape playback is stopped, press to rewind the tape at high speed. During playback, press to rewind the tape while the picture stays on the screen. Details are on page 36. Press to return to a previous menu.

REC(ord)/OTR Button Press once to start a recording. Details are on page 25. Or, press repeatedly to start a One-Touch Recording. Details are on page 27.

STATUS/EXIT Button Press to access or remove the on-screen status display. Details are on page 20. Press to exit on-screen menus.

PLAY/o Button Press to play a tape; press to release Slow, Search, or Still mode and return to normal playback. Details are on page 36. Press to select an item in the VCR menu.

MEMORY Button Press to memorize a tape position at which the real-time counter was set to 0:00:00. Details are on page 34.

POWER

 

VCR/TV

EJECT

1

2

3

 

4

5

6

 

7

8

9

CHANNEL

 

 

0

 

 

SPEED

 

TIME SEARCH

MEMORY

MENU

STATUS/EXIT

CLEAR

SLOW

REWIND

/PLAY

F.FWD

REC/OTR

/STOP

PAUSE/STILL

Image 18
Contents VCR Warranty Verification For Customer UseIntroduction FeaturesSafety Precautions Declaration of ConformityTable of Contents VCR maintenance Before Using Your VCRPutting Batteries in the Remote Control Replace the battery compartment lidHookups Without a Cable Box/Direct Broadcast System Disconnect the antenna or cable from your TVHookups Without a Cable Box/Direct Broadcast System cont’d Plug in the TV and the VCRHookups With a Cable Box/Direct Broadcast System ConnectionsRecording/Viewing Any Channel Cable Signal Cable Box/DBS Recording One Channel/Watching AnotherTV’s Antenna Hookups with a Stereo TV VR602BMGTurning on Your VCR 2Turn on the TVPress the Menu button. The display shown below will appear Automatic Channel Setup Press the Menu buttonVR602BMG only Automatic Channel Setup cont’d Adding/Deleting ChannelsReviewing Memorized Channels Press the STATUS/EXIT button once or twice to exitSetting the Clock Enter a 0 before a single-digit numberDaylight-Savings Time Language Selection Press the STATUS/EXIT buttonRemote Control Buttons Remote Control Buttons cont’d Clear ButtonChannel o/p Buttons If you select Status ON, then select Counter only on On-Screen Status DisplaysStatus Display example only If you select Status ON, then select Counter only OFFVCR Display Panel Front Panel Rear Panel VHS Quasi Play Back Sqpb Other playback options and features are on pagesPlaying Read and follow the steps below to play a tapeInsert a tape with its record tab intact in the VCR VCR will record in a preset vol- umeRecording VCR Light does not appear, press the VCR/TV button onceRecording One Channel/Watching Another One-Touch Recording Timer Recording Do each step within 60 seconds of the previous stepDaily Timer Recording cont’d Instructions continue onTape Speeds Checking or Cancelling Timer Recordings Rerecording Tape Duplication RF coaxial cableRepeat Play Press the PLAY/o button or the STOP/p button to selectPress the F.FWD/B button so that on appears beside Real-Time Counter Memory Time Search Press the Time Search buttonSuper High Speed Searching LP/SLP Special Effects PlaybackForward and Reverse Searching SP/LP/SLP Viewing a Still PictureAutomatic Operation Features This indication is not available during tape playback Understanding On-Screen DisplaysSpecifically… MonitorMulti-Channel Television Sound System VR602BMG only cont’d Hi-Fi Stereo Sound System VR602BMG only Please see additional notes onBlue Background Helpful Hints Helpful Hints cont’d Glossary Cable Box/DBS Output Channel 03 orSpecifications Renewed Index Supplied Accessories
Related manuals
Manual 9 pages 10.87 Kb