Magnavox VR402BMG, VR602BMG owner manual Checking or Cancelling Timer Recordings

Page 31

Timer Recording (cont’d) 31

Checking or Cancelling Timer Recordings

2-4

1

 

With the VCR on and in VCR position (the VCR Light will appear on the display panel), press the MENU button.

2

Press the PLAY/o button or the STOP/p button to select PROGRAM, then press the F.FWD/B button.

3

Press the PLAY/o button or the STOP/p button to select PROGRAM REVIEW, then press the F.FWD/B button. The timer recording information for the program in the lowest numbered slot will appear on the screen. If no timer recordings are set, nothing will happen when you press the F.FWD/B button.

4

Press the F.FWD/B button repeatedly to review all pro- grammed timer recordings. If you don’t press the F.FWD/B button within 10 seconds, the VCR will automatically display infor- mation about the next programmed timer recording. This will continue until all timer recordings have been displayed. Then the menu will disappear.

5

To cancel the timer recording displayed, press the CLEAR button. Either the display will disappear or information about other timer recordings will appear. If you do not press any other buttons, the display will disappear after all timer recordings have been displayed.

6

Repeat steps 1-4 to make sure you have cleared the cor- rect timer recording.

 

POWER

 

VCR/TV

EJECT

 

1

2

3

 

 

4

5

6

 

5

7

8

9

CHANNEL

 

 

0

 

 

SPEED

TIME SEARCH

MEMORY

1

MENU

STATUS/EXIT

CLEAR

SLOW

REWIND

/PLAY

F.FWD

 

REC/OTR

/STOP

PAUSE/STILL

Helpful Hints

•CLASH may flash on the screen when you finish setting a timer recording. This means that the timer recording you just programmed and another timer record- ing overlap. The current timer recording will not take place. You may choose to cancel the overlapping timer recording.

•To stop a started timer recording, press the STOP/EJECT button on the VCR.

•If the power fails for more than one minute, programmed timer recordings will be lost. If this occurs, repeat the steps on pages 11 and 15 before reset- ting the timer recordings.

•If the preset time for a timer recording comes up during an OTR, the OTR has priority. A message will remind you when the timer recording was scheduled to begin. You may let the OTR continue; the timer recording will not take place. Or, stop the OTR and turn off the VCR immediately. The timer recording will

take place if you turn off the VCR before the timer recording’s scheduled start time.

See page 42 for more hints.

Page 30 Page 32
Image 31
Page 30 Page 32
Contents VCR For Customer Use Warranty VerificationDeclaration of Conformity FeaturesSafety Precautions IntroductionTable of Contents Replace the battery compartment lid Before Using Your VCRPutting Batteries in the Remote Control VCR maintenanceDisconnect the antenna or cable from your TV Hookups Without a Cable Box/Direct Broadcast SystemPlug in the TV and the VCR Hookups Without a Cable Box/Direct Broadcast System cont’dConnections Hookups With a Cable Box/Direct Broadcast SystemRecording/Viewing Any Channel Recording One Channel/Watching Another Cable Signal Cable Box/DBSTV’s Antenna VR602BMG Hookups with a Stereo TV2Turn on the TV Turning on Your VCRPress the Menu button. The display shown below will appear Press the Menu button Automatic Channel SetupVR602BMG only Adding/Deleting Channels Automatic Channel Setup cont’dPress the STATUS/EXIT button once or twice to exit Reviewing Memorized ChannelsEnter a 0 before a single-digit number Setting the ClockDaylight-Savings Time Press the STATUS/EXIT button Language SelectionRemote Control Buttons Clear Button Remote Control Buttons cont’dChannel o/p Buttons If you select Status ON, then select Counter only OFF On-Screen Status DisplaysStatus Display example only If you select Status ON, then select Counter only onVCR Display Panel Front Panel Rear Panel Read and follow the steps below to play a tape Other playback options and features are on pagesPlaying VHS Quasi Play Back SqpbVCR Light does not appear, press the VCR/TV button once VCR will record in a preset vol- umeRecording Insert a tape with its record tab intact in the VCRRecording One Channel/Watching Another One-Touch Recording Do each step within 60 seconds of the previous step Timer RecordingDaily Instructions continue on Timer Recording cont’dTape Speeds Checking or Cancelling Timer Recordings RF coaxial cable Rerecording Tape DuplicationPress the PLAY/o button or the STOP/p button to select Repeat PlayPress the F.FWD/B button so that on appears beside Real-Time Counter Memory Press the Time Search button Time SearchViewing a Still Picture Special Effects PlaybackForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLPAutomatic Operation Features Monitor Understanding On-Screen DisplaysSpecifically… This indication is not available during tape playbackMulti-Channel Television Sound System VR602BMG only cont’d Please see additional notes on Hi-Fi Stereo Sound System VR602BMG onlyBlue Background Helpful Hints Helpful Hints cont’d Cable Box/DBS Output Channel 03 or GlossarySpecifications Renewed Index Supplied Accessories
Related manuals
Manual 9 pages 10.87 Kb
Top Page Image Contents