Fisher FVH-E420 Initial Setup, Channel Selection Convenience, Manual Erase, Manual Programming

SC4/UF (FVH-E420 GB) Wed. Jan. 26/2000

INITIAL SETUP

To modify the RF output channel setting after the Auto setup is completed

1With the VCR turned off, press the SET button for about 3 seconds or more.

The current RF output channel setting will light on the indicator panel and will appear on the screen.

2Press the number button 3 (or 4).

After about 5 seconds, the RF channel setting value is saved, and the VCR will turn off.

Channel Selection Convenience

You can select a channel on your VCR by using one of the two methods shown below:

10-KEY RANDOM ACCESS TUNING

Select the desired channel number by using the number buttons and 100 button on the remote control. For single-digit numbers, press 0 first. For channel numbers higher than 99, press the 100 button first.

UP/DOWN SELECTION

Press and hold the CH/TRACK down (l) or up (j) (or CHANNEL on the front panel) button until the desired channel is received.

NOTE: When an inactive TV channel is selected on the VCR, the “No Signal” message appears and the sound is muted.

Manual Erase

You can eliminate unwanted channels or channels with weak or scrambled signals from the memorized channel sequence.

1Select the channel you want to erase.

2Press the CLEAR button for about 2 seconds. “Erase” is displayed on-screen for about 3 seconds. The channel is now erased from the memory.

Manual Programming

You can add channels to the memorized channel sequence by manually adding them to the tuner memory.

1Select the channel you want to add using the number buttons on the remote control.

2Press the SET button for about 2 seconds.

“Add” is displayed on-screen for about 3 seconds.

The channel is now added to the memory.

BASIC OPERATION

14