SC4/UF
NORMAL PLAYBACK
Before starting
œ Turn on the power (TV and VCR). œ Set the TV to channel 3 or 4.
œ Load a cassette.
1 Press the PLAY button.
Normal playback begins.
The tape counter starts.
The tape stops and rewinds when the end of the tape is reached.
2Press the STOP button (or STOP/EJECT on the front panel) to stop playback.
œTo rewind the tape, press the REW button.
œTo fast forward the tape, press the FF button.
NOTES:
œWhen the tape comes to a blank segment during playback, the “No Signal” message appears and the sound is muted.
œIf the playback picture shows noise or no video at all while audio is properly heard, first try the manual tracking adjustment. If this does not correct the problem, it may indicate that the video heads need maintenance. Contact an authorized service center.
Digitally-Adjusted Clean Playback
Advanced technology developed by Fisher enables your VCR to detect imperfections in the condition of a recording (an old recording that has been played back many times, for example) then automatically adjust the playback signal to deliver the best possible image.
BASIC OPERATION
TRACKING CONTROL
Tracking Control Adjustments
When you play a tape that was not recorded on this VCR, some noise may appear in the picture due to incorrect
The VCR will automatically adjust the tracking for the optimum results.
If noise still appears:
MANUAL TRACKING CONTROL
1Press and hold the CH/TRACK l or j button (or CHANNEL on the front panel) during playback to eliminate the noise streaks from the picture.
The automatic tracking control mode is canceled.
To return to automatic tracking, eject the cassette, then reinsert it.
22