Sun Microsystems B100X, B1600, AND B100S, B200X BLADE # share -F nfs /cdrom/solaris8hw1202suppcd

■4726915: SunVTS will not start because of missing XML libraries

To run SunVTS you need to load the SUNWlxml and SUNWlxmlx packages. These are not loaded by default in Solaris 8, therefore you must add them manually from the supplemental CD supplied with Solaris 8 HW 12/02. They are located in the following directory on the CD: XML_Libraries_2.4.12/Product.

To make the contents of this CD available via NFS, on the NFS server, type:

#share -F nfs /cdrom/solaris8_hw1202_suppcd

Then, to load the packages onto the server blade, access the blade’s console, and type:

#mount -F nfs server:/cdrom/solaris8_hw1202_suppcd /mn

#pkgadd -d /mnt/XML_Libraries_2.4.12/Product SUNWlxml SUNWlxmlx

■4779970: When booting a blade with the kernel debugger (kadb) enabled, a warning message appears

If you boot a blade with the kernel debugger enabled, you will see the message “WARNING: todblade: kernel debugger detected: hardware watchdog disabled”. Because you have enabled the kernel debugger, the kernel watchdog functionality cannot be used. The message simply warns you of this fact. There is no other effect upon the operating system functionality.

■4803500: If you insert a blade less than 10 seconds after removing it, the service LED is lit on the blade and chassis, and service required messages are logged After using the removefru command to make a blade safe for removal, remove the blade, and then wait at least 10 seconds before re-inserting it or before inserting another blade into the same slot.

■Shared library patches for C++ are not included in Solaris 8 HW 12/02. The 32-Bit and 64-bit shared library patches for C++ (libC.so.5, libCrun.so.1, and libdemangle.so.1) are not included in the Solaris 8 HW 12/02 release. They are available on http://sunsolve.sun.com. The numbers for these patches are: 108434-10 and 108435-10.

Chapter 4 SPARC Solaris 4-3