Frigidaire Warm & Serve Drawer Installation Instructions, General Information

WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

GENERAL INFORMATION

The Warm & Serve Drawer can be used:

•As a stand alone appliance

•As a combination Warm & Serve Drawer with a 30" (76 cm) built-in oven mounted above

IMPORTANT: The warmer drawer must be installed on a leveled surface from left to right, rear to front.

Warm & Serve Drawer Dimensions

NOTE: A 60" (152 cm) long cable is supplied with the Warm & Serve Drawer.

Stand Alone Installation

IMPORTANT: The Warm & Serve Drawer runs off a single phase three-wire 120 volt, 60 hertz, AC only electrical supply with ground.

Combination Warm & Serve Drawer/ 30" (76 cm) Built-in Oven Installation

A. HEIGHT			B. WIDTH		C. DEPTH
9 7/8 " (25 cm)		30" (76,2 cm)		24 5/8" (62,5 cm)
	D. CUTOUT		E. CUTOUT		F. CUTOUT
	HEIGHT		WIDTH		DEPTH
Min.	8 3/8" (21,3 cm)		28 1/2 " (72,4 cm)		24" (61 cm)
Max.	8 5/8" (21,9 cm)		28 3/4 " (73 cm)

A. HEIGHT		B. WIDTH			C. DEPTH
40" (101,5 cm)		30" (76,2 cm)		24 5/8" (62,5 cm)
	D. CUTOUT		E. CUTOUT		F. CUTOUT
	HEIGHT		WIDTH		DEPTH
Min.	38 1/2" (97,8 cm)		28 1/2 " (72,4 cm)		24" (61 cm)
Max.	39" (99,1 cm)		28 3/4 " (73 cm)

9