JVC DR-MH200SE Example Dubbing to an MD, When you dub from DV equipment other than a Camcorder

									EDITING EN 61
9 Press selection keys to select	, then press					Digital Audio Dubbing
ENTER. The dubbing starts.
● Playback on the external DV equipment and recording on the
					You can dub selected audio from a DVD or Audio CD disc to a
unit should start simultaneously.
● To pause dubbing, press selection keys to select				,	digital audio device.
then press ENTER. Both the unit and the external			DV		However, it is not possible to dub copy-protected discs.
equipment pause dubbing. Pressing W on the unit also works
the same way.					● Turn on the TV and select the AV mode.
10 Press selection keys to select		, then press			● Slide the TV/CABLE/SAT/DVD switch to DVD.
ENTER. Then press o. The DV equipment stops.					Example: Dubbing to an MD
11 Press selection keys to select		, then press						Recorder
ENTER.
12 Press o twice on the remote control to stop dubbing.
● Both the unit and the external DV equipment stop dubbing.
NOTES:
● Dubbing copyright guarded programmes is not possible.
● Original DV information such as the recording date and time are
not recorded.
● The superimposed indication during the operation or dubbing is							Digital audio device
not recorded.
							(MD deck, etc.)
● If the dubbing is paused while the channel is set to ADVB, you
cannot switch channels.							Optical cable		Coaxial cable
							(not supplied)		(not supplied)
When you dub from DV equipment other than a
camcorder							To [DIGITAL		To [DIGITAL AUDIO
A Perform step 1 to 4.
							AUDIO OUT		OUT (COAXIAL)]
B Locate the point from where you want to start dubbing,
							(OPTICAL)]
then stop on the DV equipment.

●If you pause the DV equipment in this step, a few

second’s still picture will be recorded at the beginning of	Player
the recorded programme.
C Set the input mode to ADV INPUTB on the DV equipment.
● If you select an input mode other than ADV INPUTB,
unwanted pictures may be recorded at the beginning of	Rear of unit
the recorded programme.

DPerform step 9 to 12.

To skip unwanted part of the source picture
Press ENTER to stop both equipment, then press selection keys
to select	.			Note for connection:
Locate the point where you want to restart dubbing by pressing I,
				Remove the protection cap from the
N, or O, then press o.				optical cable.
Press selection keys to select			, then press ENTER to
restart dubbing.			1	Connect the unit and a digital audio device using either an
		2		optional optical cable or an optional coaxial cable.
				Place a disc on the unit and load an MD on the connected
		3		digital audio device.
				Select the audio to be dubbed.
		4		Start playback slightly before the actual point from where you
				wish to start dubbing.
			5 Press W to pause playback.
		6		Select the input mode on the connected digital audio device.
		7		Press I to start playback on the unit.
		8		Start recording on the digital audio device.
		9		Stop recording on the digital audio device. Then press o to stop
				playback on the unit.

NOTE:

There may be a discrepancy of several seconds between where you intend editing to start, and where it actually starts.