JVC DR-M150SEK manual Output/Input Set, Output And L-1 Input Setting, RGB / Component

Filename [M150SEK_09Editing.fm]
M150SEK_00.book Page 57 Wednesday, June 15, 2005 4:04 PM	Masterpage:Right+

Output/Input Set

EDITING EN 57

* The boldface settings below indicate the settings at your purchase.

8 L-1 OUTPUT ^ SCART VIDEO / SCART S-VIDEO /SCART

● Turn on the TV and select an input mode such as EXT1.	RGB / COMPONENT
● Slide the TV/DVD switch to DVD.	SCART VIDEO:

If a connected appliance’s input is compatible only with regular video signals, set to ASCART VIDEOB.

SCART S-VIDEO:

If a connected appliance’s input is compatible with Y/C signals, set to ASCART S-VIDEOB. You can obtain a high-quality picture. (For connection, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.)

Selection Keys

(FGDE)

ENTER

SCART RGB:

If a connected appliance’s input is compatible with RGB signals, set to ASCART RGBB. You can obtain a high-quality RGB picture.

COMPONENT:

If a connected appliance’s input is compatible with Y/PB/PR signals, set to ACOMPONENTB. You can obtain a high-quality Y/ PB/PR picture. Switch the TV to the input that you can watch component video pictures.

SET UP

L-1 Output And L-1 Input Setting

The [L-1 IN/OUT] connector accepts and delivers either a composite signal (regular video signal) or a Y/C signal (a signal in which the luminance and chrominance signals are separated). Set AL-1 OUTPUTB and AL-1 INPUTB to the appropriate mode depending on the type of appliance connected to the unit’s [L-1 IN/OUT] connector.

1 Press SET UP to access the Main Menu screen.

2 Press selection keys to select AFUNCTION SET UPB, then press ENTER.

3 Press selection keys
		DVD SET UP		FUNCTION SET UP INITIAL SET UP
	to select AVIDEO IN/
		VIDEO IN/OUT		RECORDING SET	DISPLAY SET		OTHERS
	OUTB, then press
	ENTER.		MONITOR TYPE			16:9AUTO
4
	Press selection keys		F-1 INPUT			VIDEO
			L-1 INPUT			VIDEO
	to select AL-1
			L-1 OUTPUT			SCART VIDEO
	OUTPUTB or AL-1
	INPUTB, then press		L-2 SELECT			VIDEO/RGB
	ENTER.	SET UP		OK	SELECT WITH [CURSORS]
5 Press selection keys		EXIT		SELECT	THEN PRESS [ENTER]

to select the

appropriate setting, then press ENTER.

6Press SET UP to complete the setting.

\

8L-1 INPUT ^ VIDEO / S-VIDEOVIDEO:

If a connected appliance’s output is compatible only with regular video signals, set to AVIDEOB.

S-VIDEO:

If a connected appliance’s output is compatible with Y/C signals, set to AS-VIDEOB. You can obtain a high-quality picture. (For connection, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.)

NOTES:

●If AL-1 OUTPUTB is set to ASCART S-VIDEOBor ASCART RGBB, it is not possible to set AL-1 INPUTB to AS-VIDEOB.

●If AL-2 SELECTB is set to ASAT S-VIDEO/RGBB, it is not possible to set AL-1 INPUTB to AS-VIDEOB.

●Component video signals are not output from the [L-1 IN/OUT] connector.

●When Progressive scan mode is engaged, it is not possible to select the setting of AL-1 OUTPUTB.