LG Electronics RCT689H Dubbing from VCR to DVD, Recording from DV Input, Before DV dubbing

	60	Operating
	Dubbing
	Dubbing from VCR to DVD
	You can copy the contents of a Video tape to a
	DVD using the DUBBING button. This allows you to
	archive your old Video tapes to DVD.
	1.	Insert a blank DVD disc in the DVD deck and
		close the disc tray.
	2.	Insert the video tape you wish to copy into the
		VCR deck.
	3.	Select VCR mode by pressing VCR on the
		remote control or pressing DVD/VCR on the
		front panel.
	4.	Find the place on the Video tape from which
		you want to start dubbing using the PLAY, FF,
		REW and PAUSE functions. For best results,
		pause playback at the point from which you
4		want to record.
Operating	5.	Press the DUBBING button.
		The Dubbing popup appears.

6. Use a/dto select [YES] then press ENTER (b)

7. To stop dubbing at any other time, press Z (STOP).

Dubbing will stop automatically when the Video tape ends.

,,Note

If you press PAUSE during Dubbing mode, both the DVD and VCR decks go into Pause mode and the DUBBING button blinks on the front panel. While in Pause mode, you can adjust the VCR playback

position using PLAY, REW, FF, PAUSE/STEP, etc. The DVD deck will remain in Pause mode.

To resume Dubbing.

Recording from DV Input

Before DV dubbing

You can connect a DV-equipped camcorder to this recorder using a single DV cable for input and output of audio, video, data and control signals.

yy This recorder is only compatible with DV-format (DVC-SD, DV25) camcorders. Digital satellite tuners and Digital VIDEO video recorders are not compatible.

yy You cannot connect more than one DV camcorder at a time to this recorder.

yy You cannot control this recorder from external equipment connected via the DV IN jack (including two recorders).

yy It may not always be possible to control the connected camcorder via the DV IN jack.

yy Digital camcorders can usually record audio as stereo 16-bit/48kHz, or twin stereo tracks of 12-bit/32kHz. This recorder can only record one stereo audio track. Set [DV Record Audio] option to Audio 1 or Audio 2 as required (see page 31).

yy Audio input to the DV IN jack should be 32 or 48kHz (not 44.1kHz).

yy Picture disturbance on the recording may occur if the source component pauses playback or plays an unrecorded section of tape, or if the power fails in the source component, or the DV cable becomes disconnected.

RC689D-P.BITALLU_MFL65225535_ENG.indd 60 11. 2. 1.

��12:12