Connections
To enable you to set up your new DVD recorder+VCR, it must be connected it to your TV using either a SCART cable or a COMPONENT and associated AUDIO cable.
Connecting Antenna/Cable
1Disconnect the antenna/cable from the rear of your TV.
2Connect this cable to the jack marked RF IN (FROM ANT.) on the rear panel of the DVD Recorder + VCR.
INTRODUCTION
¥ | There are a variety of ways to connect the | Antenna | Antenna | |
|
| Cable TV | ||
| DVD Recorder + VCR to your TV and other |
|
| |
| Flat Wire |
| Wall Jack | |
| equipment. Use only one of the connections |
|
| |
| (300ohm) |
|
| |
| described below. Whichever TV connection |
|
|
|
| you use will work with all input sources. | 300/75ohm Adapter | or | or |
¥ | Please refer to the manuals for your TV, VCR, | (Not supplied) | ||
|
|
| ||
| stereo system, or other devices as necessary |
|
|
|
| to make the best connections. |
|
|
|
¥ For better sound reproduction, connect the DVD Recorder + VCRÕs AUDIO OUT jacks to the audio in jacks of your amplifier, receiver, stereo, or audio/video equipment. See ÔConnecting an Amplifier/ReceiverÔ on page 17.
Rear of DVD Recorder + VCR
CONNECTIONS
Caution
¥Make sure the DVD Recorder + VCR is connected directly to the TV, and the TV is set to the correct video input.
¥Do not connect the DVD Recorder + VCRÕs AUDIO OUT jack to the phone in jack (record deck) of your audio system.
¥Do not connect the DVD Recorder + VCR via your VCR. The DVD image could be distorted by the copy protection system.
If your cable wire is connected to your TV without a converter or descrambler box, unscrew the wire from your TV and attach it to the RF IN (FROM ANT.) jack on the rear panel of the DVD Recorder + VCR.
Use the supplied RF cable to connect between the DVD Recorder + VCRÕs OUT (TO TV) jack and the antenna input jack on your TV. With this connection, you can receive all midband, superband, and hyperband channels (all cable channels).
15