Troubleshooting
Symptom | Cause | Solution |
|
|
|
CanÕt play disc recorded on this DVD Recorder + VCR on another DVD player.
Cannot record or did not record successfully.
Timer Recording not possible.
Stereo Audio Record and/or Playback not present.
Remote control does not work properly.
The disc was not finalised (or not made compatible if using a DVD+RW). Some players will not play even a finalised disc.
Discs recorded with
The source you are trying to record is
When setting the recording channel, the channel is tuned on your TVÕs tuner. Clock in DVD Recorder + VCR is not set to correct time.
Timer has been programmed incorrectly.
TIMER indicator light does not appear after programming timer.
TV is not
DVD Recorder + VCR A/V Out jacks are not connected to TV A/V In jacks.
DVD Recorder + VCR Audio/Video Out is not selected for viewing at the TV. DVD Recorder + VCRÕs TV audio channel is set to BIL or MONO.
The remote control is not pointed at the remote sensor of the DVD Recorder + VCR.
The remote control is too far from the DVD Recorder + VCR.
There is an obstacle in the path of the remote control and the DVD Recorder + VCR.
The batteries in the remote control are dead.
Finalise the disc; see page 30.
No solution.
No solution.
Use another disc.
You cannot record the source.
Select the channel on the DVD Recorder + VCRÕs
Set clock to correct time. See ÔSet ClockÔ on page 22.
Reprogram Timer. See ÔTimer RecordingÔ on page 48~50.
Reprogram Timer.
No solution.
No solution.
Make A/V connections. Stereo is available only via A/V output from DVD Recorder + VCR.
Select AUX or A/V source as TV input. Set TV audio channel mode to Stereo. See ÔChanging the TV Audio ChannelÔ on page 34.
Point the remote control at the remote sensor of the DVD Recorder + VCR.
Operate the remote control within 23 ft (7m).
Remove the obstacle.
Replace the batteries.
RESET : If the set is in malfunctions, unplug the power cord, and then plug it in after 5 seconds. As this set is a Digital Multimedia Product, malfunction may occur.
REFERENCE
57