Daewoo DQR-1000D Want, 2Confirm with OK, Field, 5Confirm with OK Close the tray, Clean the disc

The wrong TV channel was decoded (entered) after you programmed a recording using ShowView System.

There is picture or sound interference on TV reception:

Distorted sound coming from a connected hi fi amplifier.

The picture is distorted or black and white during playback.

No sound signal at the digital output.

Before you call an engineerBefore you call an engineer

➠ 1Enter the ShowView programming number of the TV channel you	A DVD+RW disc cannot be	➠ If a recording is too short, it is possible that a DVD player cannot
want.	played on certain DVD players.	detect it: Please observe the following 'Minimum recording times':
2Confirm with [OK] .		Recording mode : ‘HQ’ : 5 minutes, ‘SP’ : 10 minutes, ‘SP+’ : 13
3Check the programme number/channel name in the “Prog'' input		minutes, ‘LP’ : 15 minutes, ‘EP’ : 20 minutes, ‘EP+’ : 30 minutes
field.		➠ Some DVD players cannot play back DVD+RW recordings. You can
4If this does not correspond to the TV channel you want, select the		solve this problem by using a special function:
input field and change the programme number/channel name.		1Open the disc tray with [OPEN/CLOSE]. Insert the disc but do not
5Confirm with [OK].		close the tray.
		2Hold down the number button [2] on the remote control until the
➠ Switch to recording mode 'HQ' with REC MODE during playback
		tray closes. The disc is modified.
from the internal TV tuner ( [OUTPUT] button). This will help achieve		3If this fails to produce the desired result, repeat the procedure using
the best possible picture quality. Before recording, select the		the number button [3] on the remote control.
recording mode as described in chapter 'Manual Recording', section		4You can restore the disc to its original condition by pressing [1].
'Selecting the recording mode (quality)'.		Warning!) There is a risk that you can no longer play the disc on
➠ Have your aerial checked.		other DVD players after this procedure. Therefore, apply this
		function with particular care.
➠ The DVD recorder is connected to the 'Phono-input' of your
	Other disc errors.
amplifier: This socket is provided only for record players without a		➠ If it is impossible to play back a disc, you can try and repair it for
preamplifier. Select a different audio input.		new recordings using the following function. This will only prepare
		the disc for erasing. It will not be erased, however, until the
➠ The TV system of the disc does not match that of your TV set
		recording has been completed.
(PAL/NTSC).		1 Clean the disc.
➠ The recording can be made in colour only when the TV channels or		2 Open the disc tray with [OPEN/CLOSE]. Insert the disc but do not
the connected additional device send a colour signal. Black-and-		close the tray.
white signals containing no colour information (colour subcarriers)		3 Hold down [CLEAR] on the remote control until the tray closes. The
cannot be recorded.		disc is prepared for erasing.
		4 Start recording as with an empty disc.
➠ Check whether the sound settings match the selected inputs and

connected additional devices.

➠ Check whether you have inserted an MP3 CD: In accordance with SDMI (Secure Digital Music Initiative), the digital audio output is turned off during MP3 playback. This is not a defect of your DVD recorder.

MISCELLANEOUS

60 61