Daewoo DF-4501P user manual ImportantI t t Safeguards, Avoid direct exposure to beam

Page 3

ImportantI t t Safeguards

Important Safeguards

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated ‘dangerous voltage‘ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and servicing instructions in the literature accompanying the appliance.

This set has been designed and manufactured to assure personal safety. Improper use can result in electric shock or fire hazard. The safeguards incorporated in this unit will protect you if you observe the following procedures for installation, use and servicing. This unit is fully transistorized and does not contain any parts that can be repaired by the user.

1 READ INSTRUCTIONS

All the safety and operating instructions should be read before the unit is operated.

2 RETAIN INSTRUCTIONS

ventilation to ensure reliable operation of the unit and to protect it from overheating. These openings must not be blocked or covered. These openings must not be blocked by placing the unit on a bed, sofa, rug, or other similar surface. This unit should never be placed near or over a radiator or heat radiator. This unit should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s instructions have been adhered to.

10 POWER SOURCES

INTRODUCTION

WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

IMPORTANT FOR LASER PRODUCTS

LASER This Digital Video Disc Player employs a Laser System. To ensure proper use of this product please read this owner’s manual carefully and retain for future reference. Should the unit require maintenance, contact an authorized service location - see service procedure.

Use of control adjustments or the performance of procedures other than those specified may result in hazardous radiation exposure.

To prevent direct exposure to the laser beam, do not try to open the enclosure. Visible laser radiation when open and interlocks defeated.

DO NOT STARE INTO THE BEAM.

DANGER

Visible laser radiation when open and interlock failed or defeated.

 

 

Avoid direct exposure to beam.

CLASS 1

CAUTION

 

Do not open the top cover. There are no user serviceable parts inside the

LASER PRODUCT

 

Unit; leave all servicing to qualified service personnel.

 

CAUTION Any changes or modification in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

The safety and operating instructions should be retained for future reference.

3 HEED WARNINGS

All warnings on the unit and in the operating instructions should be adhered to.

4 FOLLOW INSTRUCTIONS

All operating and use instructions should be followed.

5 CLEANING

Unplug this unit from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

6 ATTACHMENTS

Do not use attachments unless recommended by the unit’s manufacturer as they may cause hazards.

7 WATER AND MOISTURE

Do not use this unit near water- for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool.

8 ACCESSORIES

Do not place this unit on an unstable cart, stand, tripod, bracket, or table. The unit may fall, causing serious injury to a child or adult as well as serious damage to the unit. Use this unit only with a cart, stand , tripod, bracket, or table recommended by the manufacturer.

8A A unit and cart combination

PORTABLE CART WARNING

should be moved with care.

(symbol provided by RETAC)

Quick stops, excessive force,

 

and uneven surfaces may

 

cause the product and cart

 

combination to overturn.

 

9 VENTILATION

Slots and openings in the case are provided for

This unit should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your dealer or local power company. For units intended to operate from battery power, or other sources, refer to the operating instructions.

11 POWER-CORD PROTECTION

Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit.

12 LIGHTNING

For added protection for this unit during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the unit due to lightning and power line surges.

13 DISC TRAY

Keep your fingers well clear of the disc as it is closing. It may cause serious personal injury.

14 OVERLOADING

Do not overload wall outlets of extension cords as this can result in a risk of fire or electric shock.

15 OBJECT AND LIQUID ENTRY

Never push objects of any kind into this unit through openings as they may touch dangerous voltage points or ‘short-out’ parts that could result in a fire or electric shock. Never spill liquid of any kind on the unit.

16 BURDEN

Do not place a heavy object on or step on the product. The object may fall, causing serious

ii

 

 

 

iii

 

 

Image 3
Contents DVD Recorder + VCR For your own Safety Safetyty InstructionsI t tiAlcohol- based cleaning agents PrecautionsAll operating and use instructions should be followed ImportantI t t SafeguardsUnit leave all servicing to qualified service personnel Avoid direct exposure to beamTable of Contents Number of this player, the disc cannot be played OverviewiNearest dealer To clean the cabinetTo keep the surface clean Surface of the unit To obtain a clear pictureIdentification of Controls Selects VCR mode Selects DVD mode Standby modeOTR Recording mode Recording Pause modeConnect to a TV with Component Video Y Pb Pr inputs Plug into a power outletRecover from system down Connect to a TV or other equipment with audio inputsSatellite decoder or set top box ConnectionsiCH52 Corresponding scart socket at the back of aConnecting an Amplifier/Receiver Connecting Optional EquipmentConnecting a Digital Camcorder DV model only Go to page 50~52 Go to page 42~44 Initial InstallationInitial Setup Go to page 17~28 Go to page 47~49Enter the date and time ‘Recording Options’ Settings Press SETUP. The Setup menu appearsFollow the same procedure as the ‘DVD Record Quality’ Select the PR number you want to edit using …/†Press √. The ‘Video‘ submenu is displayed Follow the same procedure as the OSD LanguageDisplays Use œ and √ to select ‘LanguageUse …/† to select the desired digital output type No signal will be output from the Digital Audio Out jacksWhile ‘Preferences Press √. The ‘Audio‘ submenu is displayedPress Enter to display the submenu Password then press EnterConfirm, press Enter Use …/† to select ‘VCR‘On-Screen Displayi l Overviewverview DVD Playback You can change the TV audio using the Audio buttonTrack Interval won’t be displayed in PBC on mode ConfirmZoom function may not work on some DVDs To return to normal playback, press Play VCR PlaybacklOther Disci Playbackl Prepare a CD which includes both MP3 and Jpeg filesInsert the CD and play an MP3 file Make sure your TV input is set to view the DVD Recorder+VCR Basicic RecordingiDVD Recorder can play DivX files on CD-R/RW Follow the instructions below to record a TV programDuring one touch copy you can search and resume copy Insert the VHS videotape you wish to copy into the VCR deckInsert a blank VHS videotape into the VCR deck To stop copying at any time, press StopTimer Recording using ShowView VideoPlus system Timer Recording‘Timer Recording’ menu appears Timer Recording using Manual Set Record ScreenYou should set only one Timer Recording Only one Timer recording will workRecording from an Externalxternal InputInput Erase the disc DVD±RW Disc OperationDisc Initialize Disc Operation in DVD±RW discPress …/† to select ‘Disc Info’ Use …/† to select ‘Finalize’ menuUse …/† to select ‘Adapt’ menu If you want to adapt the whole disc, press EnterCharacter or function and press Enter Select ‘Label’ using … †Disc Edit Press Enter to change the title nameTroubleshooting Your TV’s tuner Timer Recording not Made compatible if using aNo solution Finalized disc Discs recorded with copy-once No solutionTechnicali l Specificationsi i ti