Daewoo DF-4501P user manual To clean the cabinet, Surface of the unit To obtain a clear picture

Page 6

Overview

About DVD Recording

Notes on Recording

•The recording times shown are not exact because the DVD Recorder+VCR uses variable bit-rate video compression. This means that the exact recording time will depend on the material being recorded.

•When recording a TV broadcast, if the reception is poor or the picture contains interference, the recording times may be shorter.

•Discs recorded at high speeds (equal to or greater than 2X) may not be recognized.

•If you record still pictures or audio only, the recording time may be longer.

•The displayed times for recording and time remaining may not always add up to the exact length of the disc.

•The available recording time may decrease if you heavily edit a disc.

•When using a DVD+R disc, you can keep recording until the disc is full, or until you finalize the disc. Before you start a recording session, check the amount of recording time left on the disc.

Recording TV Audio Channels

The DVD Recorder+VCR can record one or two channel audio. For TV broadcasts, this usually means mono or stereo, but some programs are broadcast with a main and a SAP (Secondary Audio Program) audio channel. You can record either the main audio or the SAP audio.

Overview

Use a soft, dry cloth. If the surfaces are extremely dirty, use a soft cloth lightly moistened with a mild

INTRODUCTION

Cleaning the Unit

 

To clean the cabinet

 

detergent solution. Do not use strong solvents such as alcohol, benzine, or thinner, as these might damage

 

the surface of the unit.

 

To obtain a clear picture

 

The DVD Recorder+VCR is a high-tech, precision device. If the optical pick-up lens and disc drive parts are

 

dirty or worn, the picture quality will be poor. Regular inspection and maintenance are recommended after

 

every 1,000 hours of use. (This depends on the operating environment.) For details, please contact your

 

nearest dealer.

 

Remote Control Operation Range

 

Point the remote control at the remote sensor and press the buttons.

 

Distance: Within 23 ft (7 m) of the remote sensor.

 

Angle: Within 30° in each direction of the remote sensor.

 

Remote Control Battery Installation

 

Detach the battery cover on the rear of the remote control, and insert two AAA

 

batteries. Make sure the polarities (+ and -) are aligned correctly.

 

Restrictions on Video Recording

•You cannot record copy-protected video using this DVD Recorder+VCR. Copy-protected video includes DVD- Video discs and some satellite broadcasts. If copy-protected material is encountered during a recording, recording will pause or stop automatically and an error message will be displayed on-screen.

•Video that is ‘copy-once only’ can only be recorded using DVD+RW discs with CPRM.

Copyright Notice

• Audio and video recordings you make using the DVD Recorder+VCR are for your personal use only. You may

not sell, lend, or rent them to other people.

AAA

AAA

Notes on Discs

Handling Discs

Caution

Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.).

• This product incorporates copyright protection technology that is protected by method claims of certain

U.S.patents and other intellectual property rights owned by Macrovision Corporation and other rights

owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is

intended for home and other limited viewing uses only unless otherwise authorized by Macrovision

corporation. Reverse engineering or disassembly is prohibited.

Precautions

Handling the Unit

When shipping the unit

The original shipping carton and packing materials come in handy. For maximum protection, re-pack the unit as it was originally packaged at the factory.

When setting up the unit

The picture and sound of a nearby TV, VCR, or radio may be distorted during playback. In this case, position the unit away from the TV, VCR, or radio, or turn off the unit after removing the disc.

To keep the surface clean

Do not use volatile liquids, such as insecticide spray, near the unit. Do not leave rubber or plastic products in contact with the unit for a long period of time. They will leave marks on the surface.

Do not touch the playback side of the disc. Hold the disc by the edges so that fingerprints will not get on the surface. Do not stick paper or tape on the disc.

Storing Discs

After playing, store the disc in its case.

Do not expose the disc to direct sunlight or sources of heat, or leave it in a parked car exposed to direct sunlight, as there may be a considerable temperature increase inside the car.

Cleaning Discs

 

 

Fingerprints and dust on the disc can cause poor picture quality and

 

 

sound distortion. Before playing, clean the disc with a clean cloth.

Yes

No

Wipe the disc from the center outward.

Do not use strong solvents such as alcohol, benzine, thinner, commercially available cleaners, or anti-static spray intended for older vinyl records.

About Symbols

About the Symbol

‘ ‘ may appear on the TV screen during operation. This icon means the function explained in this User's Guide is not available on that specific disc.

4

 

 

 

5

 

 

Page 5 Page 7
Image 6
Page 5 Page 7
Contents DVD Recorder + VCR Precautions Safetyty InstructionsI t tiAlcohol- based cleaning agents For your own SafetyAvoid direct exposure to beam ImportantI t t SafeguardsUnit leave all servicing to qualified service personnel All operating and use instructions should be followedTable of Contents Overviewi Number of this player, the disc cannot be playedSurface of the unit To obtain a clear picture To clean the cabinetTo keep the surface clean Nearest dealerIdentification of Controls Recording Pause mode Standby modeOTR Recording mode Selects VCR mode Selects DVD modeConnect to a TV or other equipment with audio inputs Plug into a power outletRecover from system down Connect to a TV with Component Video Y Pb Pr inputsCorresponding scart socket at the back of a ConnectionsiCH52 Satellite decoder or set top boxConnecting an Amplifier/Receiver Connecting Optional EquipmentConnecting a Digital Camcorder DV model only Go to page 17~28 Go to page 47~49 Initial InstallationInitial Setup Go to page 50~52 Go to page 42~44Enter the date and time Select the PR number you want to edit using …/† Press SETUP. The Setup menu appearsFollow the same procedure as the ‘DVD Record Quality’ ‘Recording Options’ SettingsUse œ and √ to select ‘Language Follow the same procedure as the OSD LanguageDisplays Press √. The ‘Video‘ submenu is displayedPress √. The ‘Audio‘ submenu is displayed No signal will be output from the Digital Audio Out jacksWhile ‘Preferences Use …/† to select the desired digital output typeUse …/† to select ‘VCR‘ Password then press EnterConfirm, press Enter Press Enter to display the submenuOn-Screen Displayi l Overviewverview You can change the TV audio using the Audio button DVD PlaybackTrack Interval won’t be displayed in PBC on mode ConfirmZoom function may not work on some DVDs VCR Playbackl To return to normal playback, press PlayOther Disci Playbackl Prepare a CD which includes both MP3 and Jpeg filesInsert the CD and play an MP3 file Follow the instructions below to record a TV program Basicic RecordingiDVD Recorder can play DivX files on CD-R/RW Make sure your TV input is set to view the DVD Recorder+VCRTo stop copying at any time, press Stop Insert the VHS videotape you wish to copy into the VCR deckInsert a blank VHS videotape into the VCR deck During one touch copy you can search and resume copyTimer Recording using Manual Set Record Screen Timer Recording‘Timer Recording’ menu appears Timer Recording using ShowView VideoPlus systemYou should set only one Timer Recording Only one Timer recording will workRecording from an Externalxternal InputInput Disc Operation in DVD±RW disc Disc OperationDisc Initialize Erase the disc DVD±RWIf you want to adapt the whole disc, press Enter Use …/† to select ‘Finalize’ menuUse …/† to select ‘Adapt’ menu Press …/† to select ‘Disc Info’Press Enter to change the title name Select ‘Label’ using … †Disc Edit Character or function and press EnterTroubleshooting Finalized disc Discs recorded with copy-once No solution Made compatible if using aNo solution Your TV’s tuner Timer Recording notTechnicali l Specificationsi i ti
Top Page Image Contents