Swann H.264 manual Before You Begin, English, Introduction, FCC Verification, Important Note

Page 2
Introduction

Introduction

English

Before You Begin

FCC Verification

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment and the receiver

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

Consult the dealer or an experienced radio/TV technician for help

These devices comply with part 15 of the FCC Rules. Operation is subject to the following two conditions:

These devices may not cause harmful interference, and

These devices must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

All jurisdictions have specific laws and regulations relating to the use of cameras. Before using any camera for any purpose, it is the buyer’s responsibility to be aware of all applicable laws and regulations that prohibit or limit the use of cameras and to comply with the applicable laws and regulations.

FCC Regulation (for USA): Prohibition against eavesdropping

Except for the operations of law enforcement officers conducted under lawful authority, no person shall use, either directly or indirectly, a device operated pursuant to the provisions of this Part for the purpose of overhearing or recording the private conversations of others unless such use is authorized by all of the parties engaging in the conversation.

WARNING

Modifications not approved by the party responsible for compliance could void user’s authority to operate the equipment.

IMPORTANT SAFETY INSTRUCTIONS

Make sure product is fixed correctly and stable if fastened in place

Do not operate if wires and terminals are exposed

Do not cover vents on the side or back of the DVR and allow adequate space for ventilation

DEFAULT PASSWORD INFORMATION

To ensure your privacy, this DVR supports password protection.

The default, all-access username is “admin”. If the DVR asks you to log in before you’ve set a password, enter admin as your username and leave the password blank. This will give you access to all areas of the DVR.

The password function is disabled by default. However, if you’re asked for a password, the default is “12345”.

To ensure your ongoing privacy, we strongly recommend setting a password as soon as possible. Choose something that you’ll remember, but that others would be unlikely to guess.

If you do manage to lock yourself out of the DVR, you’ll need to contact us at the Swann Technical Support Telephone Helpdesk - the number is on the back cover.

2

Image 2
Contents English English4 or 8 Channel H.264 DVR DEFAULT PASSWORD INFORMATION Before You BeginIMPORTANT SAFETY INSTRUCTIONS EnglishIntroduction ContentsEnglish ReferenceGetting the DVR Setup IntroductionThe Basic Setup Stage 1. Connecting the DVR page 6 to page• Use only the supplied power adapter Installation Guidelines• Only install the DVR in a well ventilated space EnglishEnglish Front Panel of the DVRConnecting the DVR The Rear Panel of the DVR EnglishEnglish Connection DiagramConnecting the DVR English Connecting Additional DevicesConnecting the DVR Basic Setup Default Password InformationBasic DVR Operation The Remote Control•Setting the Date, Time and your Time Zone Basic Setup: GeneralBasic Setup Setting up a Dynamic DNS for remote accessNetwork Access Basic Setup: HDD & NetworkingBasic Setup EnglishEnable SSL or TLS: Enable Basic Setup: DDNS & EmailBasic Setup EnglishDST Configuration Basic Setup: NTP & DSTBasic Setup EnglishAccount Configuration Basic Setup: Account Configuration & CompletionBasic Setup Finishing the Setup WizardBasic Setup Basic Setup: Installing MyDVR on PCGot a Mac? How to install MyDVRBasic Setup MyDVR: Logging InDefault Password Information If you’re accessing the DVR via the InternetBasic Setup MyDVR InterfaceNeed more details? EnglishBasic Setup MyDVR: Local ConfigurationPlayback Problems? EnglishDisplay: Channel Settings see page MyDVR Configuration OverviewBasic Setup Recording: Advanced Config see page•NTP Setup see page Basic SetupNetwork: Advanced Config see page •Email Setting see pageAlarm: Video Loss see page Basic SetupAlarm: Motion Detection see page Alarm: Exception see pageDevice: PTZ see page Basic SetupEnglish System General see pageEnglish Remote Access From a Mobile DeviceBasic Setup Basic Setup Default Password InformationOperating the DVR Locally EnglishEnglish Menu LayoutBasicSetup ShutdownBy Default Advanced ConfigurationAdvanced Configuration Advanced Configuration includeEnglish Display: CameraAdvanced Configuration English Display: OutputAdvanced Configuration Standard 4:3 - 1024 xEnglish Recording: EncodeAdvanced Configuration English Recording: OptionAdvanced Configuration English Recording: ScheduleAdvanced Configuration Important Guidelinesusing at the time Search: PlaybackAdvanced Configuration EnglishTo backup footage Search: BackupAdvanced Configuration The Backup File ListAdvanced Configuration Search: EventSearch: Log Search EnglishEnglish The Playback InterfaceAdvanced Configuration Remember: Playback LimitationsEnglish Network: GeneralAdvanced Configuration English Network: AdvancedAdvanced Configuration What port numbers should I use?Configuration Network: Advanced: DDNSNetwork: Advanced: NTP EnglishAdvanced Configuration Network: Advanced: IP FilterNetwork: Network Status EnglishEnglish Network: Advanced: Email SettingsAdvanced Configuration Gmail GoogleEnglish Alarm: MotionAdvanced Configuration How Motion Detection WorksEnglish Alarm: Motion Detection ConfigurationAdvanced Configuration To set the MOTION DETECTION AREAEnglish Alarm: Motion Detection NotesAdvanced Configuration Motion Detection CompatibilityAdvanced Configuration Alarm: Motion Detection - ActionAlarm: Video Loss Alarm: Video LossEnglish Alarm: ExceptionAdvanced Configuration Advanced Configuration Device: HDDDevice: S.M.A.R.T EnglishPTZ Settings Device: PTZAdvanced Configuration Note for Remote Access and Mobile Device usersPTZ Controls Advanced ConfigurationEnglish support this functionEnglish System: GeneralAdvanced Configuration English System UserAdvanced Configuration English System: System InformationAdvanced Configuration To export your settings System: MaintenanceAdvanced Configuration •Choose Configuration: Import/ExportReference TroubleshootingEnglish Reference Addendum: Third Party HardwareEnglish RoutersEnglish Technical SpecificationsGet up to Date Information ReferenceEnglish Warranty InformationWarranty Terms & Conditions ReferenceNotes EnglishEnglish Swann Technical Support Helpdesk / TechnicalSupport DetailsEnglish AllCountries E-mail:tech@swann.com
Related manuals
Manual 76 pages 44.2 Kb