Magnavox ZV450MW8A Precautions, Laser Safety, Make your contribution to the environment

Page 2

PRECAUTIONS

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

The caution marking is located on the rear of the cabinet.

Laser Safety

This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.

CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

CAUTION: VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK DEFEATED. DO NOT STARE INTO BEAM.

LOCATION: INSIDE, NEAR THE DECK MECHANISM.

FCC WARNING- This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

RADIO-TV INTERFERENCE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

A NOTE ABOUT RECYCLING

This product’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

Make your contribution to the environment!!!

Used up batteries do not belong in the dust bin.

You can dispose of them at a collection point for used up batteries or special waste. Contact your council for details.

For Customer Use:

Read carefully the information located at the back of this unit and enter below the Model No. and Serial No. Retain this information for future reference.

Model No. _____________________

Serial No. _____________________

2EN

Image 2
Contents ZV450MW8A Make your contribution to the environment PrecautionsLaser Safety Important Safeguards PrecautionsAvoid the Hazards of Electrical Shock and Fire Installation LocationSupplied Accessories Moisture Condensation WarningCleaning discs Maintenance ServicingCleaning the cabinet Cleaning the disc lens Disc handlingContents Contents Features Description refers to DVD+RW Description refers to DVD-RW FeaturesSymbol Description 13 12 11 Functional OverviewFront Panel 21 2019 18 11 10 Functional OverviewRear Panel Close the cover Remote ControlOpen the cover Insert batteries 2625REW E button DVD/VCR DVD mode Confirm button DVD/VCR Analog modeNumber buttons Digital mode VCR modeCurrent status of the unit Front Panel DisplayDisplay Message Displays the followingSupplied cables used in this connection are as follows Refer to Initial Setting onAntenna Cable Connection Plug in the power cords of the devices to the AC outlet RF Modulator ConnectionWith this setup You cannot record one channel while watching another channelAvailable on DVD only Method Analog audio Good picture Connection to a TVThis unit Method Better pictureAudio SettingConnection to AN Audio System Connection Dolby DigitalFinding the Viewing Channel on Your TV Proceed to in Initial Setting onBefore YOU Start Turn on your TVDisc Information / Menu Before YOU StartGuide to On-Screen Display / Menu This is an example screen only for explanation Title Name InformationFile Name Information Main Menu How to Insert a Disc Switching DVD / VCR ModeHow to Insert a Disc / Cassette Tape How to Insert a Cassette TapeInitial Setting Setting onAuto Channel Scan Channel SettingWhen scanning is over, press Setup to exit ScanningAdding / Deleting Channels Channel SettingPreset, then press OK Use K / L to select Channel, then press OKSelect the channel number to delete Press Setup to exitSelect the channel number to add or delete Use K / L to select Add or Delete, then press OKSetting the Clock Auto Clock SettingDaylight Saving Time Setting the ClockManual Clock Setting Channel Selection Tuner SettingsSwitching Analog Mode Digital Mode Tuner Settings Selecting TV AudioSAP secondary audio program Selecting TV Audio cont’dStereo DTV Closed Caption Select if you do not want DTV CC. This is the defaultService 1 to Service Use K / L to select DTV CC, then press OKUse K / L to select User Setting, then press OK Closed Caption StyleWant to set, then press OK Switch the setting for each item youUse K / L to select the item Recordable Discs Recording ModeInformation on DVD Recording Unrecordable DiscsPress Setup to exit Setting for Auto ChapterPress Setup and use K / L to select General Before RecordingDesired channel to record Press REC Mode to select a recording modeRefer to Recording Mode on Follow the steps to record TV programsPress Stop C to exit the title list Press REC I repeatedly until the desired length appearUse K / L to enter the date, then press B Timer RecordingPress Timer Use K / L to select New ProgramPress Timer SET to set a timer programming Timer RecordingUse K / L to select a recording mode Stop C on the remote control is not effective To stop the timer recording in progressHow to select a channel number for the timer recording Press Timer SET Check the informationHints for Timer Recording Priority of Overlapped SettingsTitle Overwriting Unnecessary TitleOverwriting from the Beginning Overwriting in the Middle of the TitleOverwrite recording a Existing title B After overwriting Overwriting Unnecessary TitleHints for Overwriting Overwrite recording a Existing title B Existing title CUse K / L to select Video Input, then press OK Settings for AN External DeviceConnection to an External Device External devicePress VCR Settings for AN External DeviceRecording from an External Device Recording to a DVDPress DVDUse K / L to select Dubbing Mode, then press OK BI-DIRECTIONAL DubbingUse K / L to select Recording, then press OK Preparing for dubbing cassette tape to DVDPress Stop C to stop the dubbing BI-DIRECTIONAL DubbingUse K / L to select VCR DVD, then press OK Use K / L to select DVD VCR, then press OKUse K / L to select Yes, then press OK Setting a Disc to ProtectTo cancel the disc protect Use K / L to select Finalize, then press OK Press Setup Use K / L to select Disc Edit, then press OKFinalizing a Disc Finalizing is completedPlaying the Discs on Other DVD Players Auto FinalizingUnplayable Discs Information on PlaybackPlayable Discs and Files Color SystemsPBC playback control for Video CD CD Playback Mode menu will appearInformation on Playback Hint for DVD PlaybackPress Play B to start playback Basic PlaybackDirect Playback Press Stop C once to stop playback temporarilyUse K / L to select a desired title Basic PlaybackPlayback from the Title List Use K / L to select Play, thenPlaying Back an Audio CD and a CD-RW/-R with MP3 Files When selecting track/fileWhen selecting the folder Not available for audio CD Hints for audio CD tracks and MP3 filesDuring playback, press Pause F Using the Title / Disc MenuPause Playback will be paused and sound will be mutedFast Forward / Fast Reverse Playback Special PlaybackResume Playback Skipping TV Commercials During PlaybackSlow Forward / Slow Reverse Playback Special PlaybackStep by Step Playback ZoomMarker Setting Repeat PlaybackUse K / L to select Random Play, then press OK Random PlaybackProgram Playback 5Press Play BSearch Using H / GUsing Display Title / Chapter SearchAudio CD SearchTime Search For DVD-video Audio soundtrack will switch Switching SubtitlesSwitching Audio Soundtrack Selecting the Format of Audio and Video Switching Virtual Surround SystemSwitching Camera Angles Reducing Block NoiseEditing Discs Information on Disc EditingGuide to a Title List Press DVD, then press TitlePress DVD first Press Title Editing DiscsDeleting Titles Use K / L to select Title Delete, then press OKUse K / L to select Edit Title Editing DiscsPutting Names on Titles After this operation is completed, press Return to exitPress Return twice to exit Setting Chapter MarksUse K / L to select Add, then press OK Submenu will appearClearing Chapter Marks Selected chapter mark will be deletedFollow steps 1 to 3 in Deleting Clearing Chapter Marks cont’dTo delete all chapter marks Use K / L to select Delete AllHiding Chapters Picture for thumbnail will be set Setting Pictures for ThumbnailsPress Return to exit Dividing a Title You can divide one title into 2 new titlesPutting Name on Disc Setting or Releasing Disc Protect Erasing Disc You can erase all titles on a discMaking Edits Compatible Compatible, then press OKList of Settings ContentsList of Settings ONAPR-OCT OFFSetups PlaybackPlayback cont’d SetupsParental Lock Default OFF YesSubtitle Language Default OFF Disc Menu Language Default EnglishAudio Language Default Original Angle Icon Default onFor 4 refer to pages DisplayRefer to 1 to 5 on page 87 and set the selected item FL Dimmer Default Bright OSD Language Default EnglishScreen Saver Default 10 minutes Display cont’dVideo Progressive Scan Default OFFTV Aspect Default 43 Letter Box Refer to 1 to 2 on this page and setReset All Reset the setting to defaultVCR Functions Select the recording mode using REC ModeRecording mode To resume playbackYou cannot pause the one-touch timer recording One-touch Timer Recording OTRPress REC I to begin the one-touch timer recording VCR FunctionsOther Operations Troubleshooting Symptom RemedyRepairing process MAY not work TroubleshootingOPEN/CLOSE a to take out the disc. The disc canceled during Press OPEN/CLOSE aREC Frequently Asked QuestionsDVD mode only VCR mode 3 496 EN Language Code Language CodeGlossary Recording SpecificationsGeneral TunerCódigos de Región EspañolDiscos Reproducibles Disco GrabableEspañol VHF / UHFPresione DVD Presione STANDBY-ON yPresione OK para activar Ajste Manual de Reloj Para seleccionar un modo deGrabación con Temporizador Reproducción Inserte un disco1VMN23648A Customer ServiceTel