Magnavox 1VMN26713A Setting the Clock, Auto Clock Setting, Press Setup and use K/ L to

3

below.

1

2

Select “Manual” at step 4 above, then press [OK].

Use [the Number buttons] or [K/ L] to enter your Cable TV Analog PBS channel number, then press [OK].

Set Channel No.

OFF Auto

Manual

5 Press [SETUP] to exit.

6 Press [STANDBY-ONy] to turn the unit to the standby mode.

This unit will search for the time only when the power is in the standby mode. Initially leave it in standby mode for at least 15 minutes to give this unit time to set the clock. Once the clock is set, the unit receives the clock data at 12:00 am & 12:00 pm when unit is in standby mode. Check the time after the Auto Clock was set, if it is incorrect time then set the “Auto Clock Setting“ to “OFF” in step 4 above. Then try “Manual Clock Setting“ on page 32.

Manual Auto Clock Setting

If the unit chooses an incorrect PBS channel on Cable TV, set the PBS channel manually by following the steps

Auto Clock Setting

2 Use [K/ L] to select “Clock”, then press [OK].

“Clock” menu will appear.

3 Use [K/ L] to select “Auto Clock

Setting”, then press [OK].

4 Use [K/ L] to select “Auto”, then press [OK].

SETTING THE CLOCK

Auto Clock Setting

This unit can set the time and date automatically by
	ANALOG AUTO CLOCK SETTING (Cable TV only)
referring to a channel that carries clock information. If a
	Press [SETUP] and use [K/ L] to
PBS (public broadcasting station) channel is available on
Cable in your area, follow “Auto Clock Setting” below. If	select “General Setting”, then press
not, follow “Manual Clock Setting” on page 32.
	1 [OK].
Make sure
• The cable TV connections are correct.	“General Setting” menu will appear.
• Channels are set. (Refer to page 28.)

Note

•The clock may set itself automatically after you connect the antenna/cable signal and plug in the power cord.

•Only the Analog PBS channel Cable TV signal is effective for auto clock setting.

•For analog auto clock setting, incorrect time may be obtained depending on the broadcast information. If this occurs, set the “Auto Clock Setting” to “OFF” at step 4 above and try “Manual Clock Setting” on page 32.

CH 1

Press [SETUP] to exit and turn the unit to the standby mode.

30 EN