Installation
1. Auto Installation
(1)Press the [SETUP] button to display the Setup Menu screen in TV mode.
Press the [ 
/ 
] buttons to select the line of “ Installation “ and press the [ENTER] button
to confi rm that.
(2)Press the [ 
/ 
] buttons to select the line of “Auto Installation” and press the [ENTER] button to confi rm that.
(3)After the channel searching is completed, the “Please wait” screen will appear a while.
(4)If other stations are positioned on near the current RF OUTPUT PR, the guide message appears automatically.
The VCR recommends the optimal RF OUTPUT PR number automatically.
Press the [ENTER] button to confi rm the recommended PR.
If not, press the
And then, press the [ENTER] button to confi rm. If you don’t want to exchange, press the [SETUP] button. (Please refer to the section of “RF OUTPUT SETUP” on page 25)
(5)The Clock Set screen automatically appears for manual clock set.
How to set the clock: See the CLOCK SET procedures.
(6)After completing the Auto Searching procedures, the “Manual Installation” screen appears. Whenever a channel is searched and memorized, the PR number will be increased from 01 to 99 on both LED and OSD.
During channel searching, you can press the [SETUP] button to interrupt it, then the VCR goes to the Real Picture.
COUNTRY
Australia
New zealand
ENTER: Confirm SETUP: End
This function is for you tune your TV to find the VCR channel.
1. Test Signal Generation Mode
(1) If you use the TV Aerial RF input for the VCR.
In
If press the [ENTER] button for 5 seconds again or press the [SETUP] button, the real picture will
appear.
(2)Tune the TV till it gets the clear test signal, which has the black and white pattern (2 white bar pattern).
Check whether all the received stations have bad picture quality due to the interference between the modulated signal and through signals (general broadcasting signal).
If there is, adjust the RF output channel on LED or SETUP operation.
•On LED: “RF 36” is displayed (“RF” is blinking) and it can be adjusted directly by pressing [0- 9] buttons on remote control.
•On SETUP: See the RF OUTPUT SET procedures.
2. Manual Installation
This function is for you to search new stations and add into the VCR.
(1)Press the [SETUP] button to display the Setup Menu screen in TV state.
Press the [ 
/ 
] buttons to select the line of “Installation” and press the [ENTER] button to confi rm that.
(2)Press the [ 
/ 
] buttons to select the line of “Manual Installation” and press the [ENTER] button to confi rm that.
Press the [ 
/ 
] buttons to select the re- searching channel and press the [ENTER] button to confi rm that.
•Reception - The list is: AERIAL, CABLE If aerial is selected, CH is written before the channel number. If cable is selected, CC is written before the channel number. If the user changes the reception: “AUTO SEARCH” is set to
22