FUNAI FDRV90E Functional overview cont’d, VCR/DVD recorder Switching, 60˚ Remote control

Page 9

Before you start

Functional overview (cont’d)

Installing batteries in the remote control Using a remote control

Before you start

Install two AA batteries (supplied) matching the polarity indicated inside battery compartment of the remote control.

1

2

3

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together, although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery com- partment.

•Remove batteries from equipment that is not going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction rules that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disas- semble batteries.

VCR/DVD recorder Switching

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor on the unit.

•Use within the operating range and angle as shown.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the unit.

•Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall off in the operating range of the remote control.

Within about 23feet (7m)

60˚

Remote control

Connections Getting started Recording Playing discs Editing

Because this product is a combination of a VCR and a DVD recorder, you must select first which com- ponent you wish to operate with the SELECT button.

Changing the

VCR MODE

Press the VCR button on the remote control. (Verify that the VCR SELECT indicator is lit.)

DVD MODE

Press the DVD button on the remote control. (Verify that the DVD SELECT indicator is lit.)

Note

•Pressing only the SELECT button on the front panel DOES NOT switch the mode of the remote control.You MUST select the correct mode on the remote control.

•Pressing the SETUP or the VCR Plus+ but- ton switches the unit to the DVD mode.

SELECT button

SELECT

VCR

DVD

DVD button

 

 

VCR button

DVD SELECT indicator

VCR SELECT indicator

POWER

 

 

 

OPEN/

 

 

 

CLOSE

VCR Plus+

 

.@/:

ABC

DEF

SEARCH

 

GHI

JKL

MNO

MODE

 

 

 

 

CM SKIP

PQRS

TUV

WXYZ

ZOOM

 

 

SPACE

 

CLEAR/

 

REC

AUDIO

DISPLAY

C.RESET

MONITOR

MENU/LIST

 

 

 

TOP MENU

RETURN

 

 

 

SETUP

VCR

VIDEO/TV

DVD

SLOW

REC

 

SPEED REC/OTR

SKIP

 

 

CH

 

STOP

PLAY

 

REW

 

 

 

FWD

 

 

PAUSE

 

SETUP menu VCR functions Others Español Français

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Remote control RF cable Supplied AccessoryNA817UD WPZ0901TM002 With two AA batteriesLaser Safety PrecautionsBefore you start Model No Serial NoPrecautions cont’d Important SafeguardsMaintenance Installation LocationMoisture Condensation Warning About CopyrightTable of contents Features 2221201918 1211 Functional overviewPower button DVD/VCR Skip H button DVD Setup button DVD/VCRSearch Mode button VCR CLEAR/C.RESET button60˚ Remote control VCR/DVD recorder SwitchingFunctional overview cont’d Select buttonSETUP/DISC/CD menu Display menu First DVDFirst VCR Disc type and Current status of the unit Display messageRecording speed Title/Track and Chapter markMethod 2 and method 3 are only useful in DVD mode Plug in the AC power cord of this unitConnections Connection to a TVTo select channels of the cable box or satellite box Connection to a cable box or satellite boxTo playback a DVD disc or a tape To view one channel while recording anotherConnection to an Audio System Easy DVD recording Getting startedChannel Discs Easy DVD recording Cont’dGetting channels auto- matically Channel settingSelect Manual Preset using Buttons, then press Enter button Channel setting cont’dManual Preset menu will appear Select Channel using K / L Buttons, then press Enter buttonRemember Guide channel settingAssign channel numbers to the guide channels as neces- sary Guide Channel Setting list will AppearTo continue assigning, repeat the steps To erase a TV channel, press button at stepOption window will appear Selecting the TV stereo or SAPOutputs main-audio Secondary Audio ProgramAuto Clock Setting Clock settingManual Clock Setting Clock setting cont’dClock menu will appear, then the settings will be activated Select on or OFF using Buttons, then press Enter button Setting the daylight sav- ing timeChoose on when currently observing the daylight saving time Daylight Saving Time options will appearSelect TV Aspect using K Buttons, then press Enter Letter Box has been select- ed as the defaultSelecting the TV aspect ratio Playback menu will appearInformation on DVD recording RecordingInformation Recording speedInformation on copy control Information on DVD recording cont’dMaking discs playable in other DVD player Finalize This unit cannot record CD-R or CD-RW discsSETUP/DISC menu will appear Screen Settings for the recording format to a blank discSelect Setup using / B Formatting a discPress Setup button to exit Setup menu Select Auto Chapter usingFormatting a disc cont’d Option window will appearSelect Format using K / L buttons, then press Enter button Select Yes using / B but- tons, then press Enter but- tonReformatting a disc Formatting is completeBasic recording Checking the recording picture quality Basic recording cont’dXP SP LP Press REC Monitor button again to exitOne-touch timer recording Timer recording Press Enter button when all information required is entered Timer recording cont’dPress Power button to turn off To stop the timer recording in processPriority of overlapped settings Hints for timer recordingRecord using K / L buttons When the Guide channel hasBefore setting timer recording Using VCR Plus+ system, read Guide channel setting on pages 20-21Select L1 Rear using K / L buttons, then press Enter button Settings for an external sourceConnection to an external source If you want to use Video input Composite, select VideoSelect a recording speed using REC Speed button. Refer to Settings for an external source cont’dRecording from an external source Recording speed on page 28 for DVD or page 98 for VCRDubbing Mode Select Dubbing Mode using Buttons, then press Enter buttonMake sure After setting the Dubbing When you turn off the unitMode to Setting will be set toSelect Disc using / B buttons, then press Enter button Finalizing the discsFinalizing is complete Setting a disc to protect Information on DVD play Playing discsPlayback Basic playbackFor MP3 playback Basic playback cont’dPlaying discs using the disc menu First DVD Press TOP Menu button Playing discs using the title menuTOP Menu button Press TOP Menu button to exit the title menuSpecial playback Resume playFast forward / Fast reverse Special playback cont’d Skipping TV commercials during playPause Slow forward / Slow reverse play Step by step playbackSelect icon using / B buttons, then press Enter button Spatializer setting Virtual surroundZoom During playback, press Zoom buttonThen press CLEAR/C.RESET Marker setup menu will appear. Screen for DVDScreen for CD Recording to a recordableUsing Display button Using Skip H / G buttonsSearch Title/Chapter searchSearch cont’d Enter a desired time to search using K / L buttons orTrack search Time searchRepeat/Random/Program play Repeat playRandom play Program play Repeat/Random/Program play cont’dDVD-RW VR mode Switching audio soundtrackAudio channel will switch Selecting the format of audio and videoSelecting the format of audio and video cont’d Switching subtitlesAngle will switch each time you press Enter button Switching camera anglesReducing block noise NR menu will appearEditing Editing discs in Video modeInformation on disc editing Guide to a title listInformation on disc editing cont’d Editing discs in VR modeEditing original titles Editing playlistsDeleting titles Editing DVD-RW discs in Video modeTitlelist will appear Screen Edit menu will appearSelect Edit using K / L but Editing DVD-RW discs in Video mode cont’dPutting names on titles Tons, then press Enter buttonSelect Yes using / B but Tons, then press Enter but Name you entered will beActivated for the title Setting or clearing chapter markers Select Chapter Mark using Buttons, then press Enter buttonChapter markers will be added at the specified time Editing DVD-RW discs in VR mode Original Select Scene Delete using Buttons, then press Enter button Editing DVD-RW discs in VR mode Original cont’dSelect Original using / B buttons, then press Enter button Deleting parts of titlesButton Ton Delete when the numberOption window will appear Part of a title will be deleted You cannot select SceneName you entered will be activated for the title Yes JAN/ 1 100AM CH12 Option window will appear. AddDelete Setting pictures for thumbnailsDelete Chapter marker which you Selected will be deletedPicture for thumbnail will be set To prevent accidental editing or Setting titles to protectThem from the original menu Buttons, then press First Original menu will appearReleasing titles from protecting Editing DVD-RW discs in VR mode Playlist Select PlayList using / B buttons, then press Enter buttonPlaylist will appear Instructions continue to the next Editing DVD-RW discs in VR mode Playlist cont’dPlaylist menu will appear Before editing EditedPart of a title will be deleted Select Delete using K / L buttons, then press Enter buttonButtons, then press Tons, then press Enter but Select a desired title using K Select Yes using / B butEnter button Ton Playlist menu will appear Name you entered will beDisc Setting Chapter marker will be added. Add Open Powerclose Select Edit using K / L but- tons, then press Enter but Ton Adding titles to a PlaylistOriginal/PlayList menu will appear Screen Playlist can be deleted if no longer needed Deleting a PlaylistPlaylist will be erased Ing time on discYou cannot select Chapter Mark Editing DVD-R discsEditing DVD-R discs cont’d Select Yes using / B but- tons, then press Enter but TonTour of the Setup menu Changing the Setup menuPress Setup button to display SETUP/DISC menu Settings for LanguageSETUP/DISC menu will appear Only the languages supported by the disc can be selectedSettings for Language cont’d Setup Display Settings for DisplayOSD Background Transparency Default 35% Settings for Display cont’dOSD Language Default English Screen Saver Default 10 minutesChoose the appropriate Audio settings for your equipment Settings for AudioSelect Playback using K / L / / B buttons, then press It will only affect DVD discs during playbackSelect a setting using K / L buttons, then Settings for Audio cont’dDynamic Range Control Default on Fast Forward with Audio Default OFFSettings for Parental lock level Settings for Parental lock level cont’d Press Stop button when the recording is completed Recording and One-touch timer recordingVCR functions PlaybackOne-touch timer recording Recording and One-touch timer recording cont’dIndex search You cannot pause an OTRWhen you playback a tape recorded in Hi-Fi stereo Counter ResetOther operations VCR FirstTroubleshooting Others101 102 Troubleshooting cont’d103 RF converter output Press VIDEO/TV button on the remote controlSelect channel 3 on your TV For more than105 Language codeGlossary 107 SpecificationsFácil grabación de DVD EspañolNota Mando a distancia¿Qué son títulos y capítulos? Grabe en discosPuede editar lo siguiente de la lista de títulos Original y Playlist modo VRPresione VCR Reproducción con videograbadoraGrabación y grabación con temporizador de un toque VCR GrabaciónGrabación con temporizador de un toque OTR Français TélécommandeEnregistrement simple de DVD Sélectionner la vitesseEnregistrement simple de DVD suite 114 Lecture avec magnétoscopeEnregistrement Limited Warranty
Top Page Image Contents