GoVideo DVD/VCR Combo manual VCR Operation Normal Playback, Special Effect Playbacks

Normal Playback

Preparations:

Turn on the TV.

Tune the TV to the DVD+VCR output channel (CH 3 or 4) or set the TV’s source selector to VIDEO.

If a direct VIDEO/AUDIO connection is made between the VCR and the TV, set the TV’s source selector to VIDEO.

up automatically.

Make sure that the TIMER indicator in the display window is not lighted. If it is, press POWER once. If a tape without a safety tab is inserted, the unit will start the playback automatically.

Press PLAY once.

2 The PLAY appears on the TV screen .

It is not necessary to select the tape speed for play- back. It will be automatically selected by the VCR. In playback, the TV/VCR selector switches to VCR mode automatically.

Press STOP to stop playback.

3 The STOP appears on the TV screen.

If the tape reaches the end before STOP is pressed, the VCR will automatically stop, rewind, eject, and it will turn itself off.

Tracking Control

Auto Tracking

The automatic tracking function adjusts the picture to remove snow or streaks.

The AUTO TRACKING function works in the following cases:

A tape is played back for the first time. Tape speed (SP, LP, EP) changes.

Streaks or snow appear because of scratches on the tape.

Manual Tracking

If noise appears on the screen during playback, press either TRK (+/-)on the remote control or CH (3 / 4) on the front panel until the noise on the screen is reduced.

In case of vertical jitter, adjust these controls very carefully. Tracking is automatically reset to normal when the tape is ejected or the power cord is unplugged for more than 3 seconds.

Special Effect Playbacks

Special effects playback notes

Horizontal lines (noise bars) will appear on the TV screen. This is normal.

The audio is automatically muted during special effect modes, so there is no sound during search.

During the high-speed picture search modes, a short period is needed to stabilize tape speed when re-entering the PLAY

mode. Slight interference may be observed during this period.

Search

This function lets you quickly and visually search for a desired tape section in either direction: forward and reverse.

1Press REW . or FF > during playback. The VCR will be activated in the SEARCH mode.

If the VCR is left in the SEARCH mode for more than 3 minutes, the VCR will automatically enter the PLAY mode, to protect the tape and video heads.

2To exit search mode, press PLAY.

Still Picture and Frame-by-Frame Playback

1Press PAUSE/STEP during playback. Still picture will appear on the TV screen.

If a still picture vibrates vertically, stabilize it by pressing TRK (+/-)on the remote control.

If the VCR is left in the STILL mode for more than 5 min- utes, the VCR will automatically enter the STOP mode to protect the tape and video heads.

2Press PAUSE/STEP repeatedly to advance the video picture one frame at a time while viewing a still picture.

3To exit still picture mode, press PLAY.

Slow Motion

1While in still video mode, press FF >.

The tape will be played back at a speed 1/19 times slower than the normal speed.

During slow playback, TRK (+/-)on the Remote Control can be used to minimize noise bands.

When the slow mode continues for more than 30 seconds, the VCR will automatically change to playback mode.

2To exit search mode, press PLAY.

SKIP (Commercial Skip)

This is useful for skipping commercials or short program segments.

1Press SKIP during the playback mode.

The tape will fast forward picture search through 30 seconds of recording.

The skipping time can be extended by pressing SKIP. Subsequent presses result in advancing the fast forward picture search time by 30-second increments (maximum 2 minutes).

2When the search is completed, the VCR will go into playback mode automatically.