Initial Setup
Change Password
1While ‘Preferences 
‘ is selected, press [†] to select ‘Parental Ctrl‘.
2Press [√] to select ‘Password‘. Then press [ENTER].
|
|
|
|
Preferences |
|
| |
Video |
|
|
|
Audio |
|
|
|
Parental Ctrl | Parental |
| |
Auto Settings | • Password | Change | |
VCR |
|
|
|
Modulator Out |
|
| |
… | Choose | ENTER OK | SETUP Exit |
œ √ † | |||
|
|
|
|
3The ‘Input Password’ submenu appears. Enter your current
4Enter a new
•Master Password : If you forget your password, press 3,3,0,8 on the remote control and then press [ENTER].
•Set the new password to something other than '0000'.
Input Password
Old Password
New Password
Confirm PWD
|
|
| OK |
| Cancel |
|
| Input digits |
|
| |||
|
|
| ||||
|
| … | Select | ENTER OK | ||
| œ √ † | |||||
SETUP
Various ‘Preferences’ Settings
1Press [SETUP]. The Setup menu appears.
While ‘Init Setup‘ is selected, press [ENTER] to go to the initial setup page.
2Use [œ/√] to select ‘Preferences 
‘.
3While ‘Preferences 
‘ is selected, press [†] to select ‘Auto Settings‘.
4Press [√]. The ‘Auto Settings‘ submenu is displayed.
Preferences
Video
Audio
Parental Ctrl
•Auto Settings
VCR
Modulator Out
…
œ √ † Choose
Auto Clock Set | Off |
VPS/PDC | Off |
ENTER OK | SETUP Exit |
Auto Clock Set
Auto Clock enables the DVD Recorder+VCR to set the clock automatically whenever it is in Standby mode (plugged in but powered off).
Auto Clock is only available for models with the VPS/PDC function.
Some broadcasting stations may send the time and date along with the VPS/PDC data. The video will automatically use this time and date during the initial setting up procedure during normal use, and every time you switch the video off at the mains. If you find that this time and date is incorrect you can remove this feature by following the steps below changing it to the OFF mode, you will then have to manually set the time and date, see above.
Preferences
Video
Audio
Parental Ctrl
Auto Settings
VCR
Modulator Out
…
œ √ † Choose
•Auto Clock Set | On |
VPS/PDC | Off |
ENTER OK | SETUP Exit |
1Use […/†] to select 'Auto Clock Set' and press [ENTER].
2Use […/†] to change the 'Auto Clock Set' status, and press [ENTER] to confirm.
25