Multi-Tech Systems MT2834ZDX manual Appendix a Regulatory Compliance, CFR Part 15 Regulation

Page 24

Appendix A – Regulatory Compliance

Appendix A – Regulatory Compliance

Regulatory Compliance

Regulatory Requirements for the United States

47 CFR Part 15 Regulation

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 47 CFR Part 15 regulations. The stated limits in this regulation are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

￿Reorient or relocate the receiving antenna.

￿Increase the separation between the equipment and receiver.

￿Plug the equipment into an outlet on a circuit different from that to which the receiver is connected.

￿Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the CFR 47 rules. Operation of this device is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference that may cause undesired operation.

WARNING – Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Multi-Tech Systems, Inc. MT2834ZDX User's Guide

24

Image 24
Contents MT2834ZDX-Series External Data/Fax Modem Users Guide User Guide MT2834ZDX-Series S000309A Rev. a Copyright Contents Introduction Installation Safety WarningsFeatures Getting StartedModem Installation Attach the Self-Adhesive FeetConnect the Modem to Your System Install the Modem Driver Install Data Communications SoftwareRemoving Your Old Modem from Windows Speed Indicator Blink Rates OperationFront Panel AT Commands, S-Registers Result Codes AT Commands$BAn Baud Adjust DCn AT Command ControlCarrier Detect Control CDn Cleardown at DisconnectEn Echo Command Mode Characters En V.42 Error Correction ModesEn Non-Error Correction Mode Flow Control DPn Read Line Probe Data$En V.42 Error Correction at 300 bps Load Default Configurations$Fn Enable/Disable Auto-Reliable Fallback Character Fn Echo Frequency Canceller Offset CompensationList Commands #L n V.42 Mode Selection in Originate Mode$H n Help Screens Inquire Product CodesResult Codes Enable/Disable $MBn Modem Baud RateNd Dial a Stored Number NdNe. .. Number LinkingRn Clear to Send Control RAn Asymmetrical Bit RateRDn Square Wave Ring Detect RFn CTS/RTS Interaction ControlTn Respond to Remote Digital Loopback Signal SFn DSR/CD Interaction Control$SBn Serial Port Baud Rate Tone-DialWn Store Configuration Modem ResetReturn to Command Mode Xn Result Codes and Call Progress SelectionAtcr Remote Configuration Escape Sequence +++ATCR Escape CodeBreakatcr Escape Sequence Register Unit Range Default Description RegistersResult Codes Terse VerboseTroubleshooting None of the LEDs Light When the Modem Is OnModem Dials But Cannot Connect Modem Disconnects While Online There Are Garbage Characters on the Monitor Appendix a Regulatory Compliance Regulatory ComplianceCFR Part 15 Regulation CFR Part 68 Telecom Current Requirements for Label Content and Format USAAAEQ##TxxxxRegulatory Requirements for Canada Industry Canada IC XXXXXX-ZZZZZZZZ WhereAppendix B Technical Specifications Command Buffer 60 charactersManual Control Power switch Transmit Level -13 dBm Frequency Stability +/-0.01%Appendix C Warranty and Service WarrantyOnline Warranty Registration About the Internet Index AtcrModem driver installation
Related manuals
Manual 34 pages 22.61 Kb